User manual BRANDT VH 1200 W

[. . . ] -- The electrical connection details on the manufacturer's plate on your machine must match those for the mains power supply. important: For safety's sake, do not leave your dishwasher's door fully open after use. If your dishwasher is being installed on a carpeted floor, ensure that the feet are set to leave an air space under the appliance. You can insert your appliance under an existing worktop provided that the relevant niche corresponds to the dimensions on the sketch below (Fig. [. . . ] Before connecting your appliance, ensure that: - The mains voltage indicated on the manufacturer's plate on your machine matches the voltage supplied by your installation. - Your meter and the fuses can support the current intensity for your dishwasher. If you must connect your appliance to a different voltage from that indicated on your machine, connect an appropriate transformer. nB: Use the services of a qualified electrician to make the modifications and ensure that your electrical installation complies with the regulations. This appliance must necessarily be connected directly to an earthed plug and socket. In all cases, it must be connected in accordance with the prevailing regulations in the country concerned and any additional regulations from the local electricity utility. We cannot be held responsible in the event of an accident or an incident caused by the lack of or by a defective Earthing system. Your dishwasher complies with European Directives 73/23/EEC (Low Voltage Directive) and 89/336/EEC (Electromagnetic Compatibility) as modified by Directive 93/68/EEC. For your safety's sake, this operation must only be performed by the manufacturer's After-Sales Department or by someone with similar qualifications in order to avoid any risks. The wires in your appliance's power The plug and socket must be accessible even after your appliance has been installed. The appliance must not be connected via an extension lead, a multiple socket or an electric time delay programmer C . If the cable's colours do not match your plug, proceed as follows: The wire coloured green and yellow must be connected to the connector in your plug marked with the letter E, the symbol or coloured green and yellow. The blue-coloured wire must be connected to the connector marked with the letter N or coloured black. The brown-coloured wire must be connected To the connector marked with the letter L or Clip the three cups P1 under the feet to make the dishwasher easier to slide (Fig. If the worktop is in marble or a similar material, you must fix your dishwasher using the side screws; before inserting it into the niche, you must therefore unfold a flange on each side of the side panels (Fig. Slide the appliance into the niche, TAKING SPECIAL CARE NOT TO KINK THE HOSES. Use the wrench provided to adjust them, if necessary. The central foot can be adjusted using the red wheel (screwdriver with No. The appliance must be correctly levelled so that the door closes and seals perfectly (Fig. Ensure that the dishwasher's door closes correctly, without catching or rubbing against the sides. If your worktop has a hob fitted above your dishwasher, you must fit thermal insulation on top of your dishwasher. You can obtain an insulation kit from your dealer. [. . . ] Adjust them identically on the right and the left (Fig. The door is correctly balanced when it dopes not fall heavily on opening and it remains horizontal in the open position. Refit the plinth, cutting it away if necessary according to Dimension P (see table and Fig. 1 and measure the gap J between the floor and the bottom of the dishwasher. [. . . ]