User manual BRANDT WFE1266A

[. . . ] Of course, in an ongoing effort to satisfy your demands with regard to our products as best as possible, our after-sales service department is at your disposal and ready to listen in order to respond to all of your questions and suggestions (contact information at the end of this booklet). You can also log on to our web site at www. Com where you will find all our products, as well as additional, useful information. bRANDT As part of our commitment to constantly improving our products, we reserve the right to make changes to their technical, functional and/or esthetic properties in line with their technological development. [. . . ] In case of doubt, consult your electricianinstaller. The electrical connections are made before the appliance is installed in its housing. Electrical safety must be provided by a correct build-in. During installation and maintenance operations, the appliance must be unplugged from the electrical grid; fuses must be cut off or removed. The oven must be connected with a power cable (standardized) with three 1. 5 mm2 conductors (1 ph + 1 N + ground) that must be connected to a monophase 220-240 V network via a CEI 60083 standardised receptacle (1 ph + 1 N + ground lead) or in accordance with installation rules. The safety wire (green-yellow) is connected to the appliance's terminal and must be connected to the ground lead of the electrical set-up. We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. If the oven malfunctions in any way, unplug the appliance or remove the fuse corresponding to the sector there the oven is hooked up. See the instructions on "Materials you can use in microwave oven or to be avoided in microwave oven. " There may be certain non-metallic utensils that are not safe to use for microwaving. Names of Oven Parts and Accessories Remove the oven and all materials from the carton and oven cavity. Your oven comes with the following accessories: Glass tray 1 A Turntable ring assembly 1 Instruction Manual 1 F Both glass tray and turntable ring assembly must always be used during cooking. All food and containers of food are always placed on the glass tray for cooking. Examine the oven for any damage such as dents or broken door. Cabinet: Remove any protective film found on the microwave oven cabinet surface. Do not remove the light brown Mica cover that is attached to the oven cavity to protect the magnetron. Select a level surface that provide enough open space for the intakeand/or outlet vents (no built in). 5cm) is required between the oven and any adjacent walls. (2) Do not remove the legs from the bottom of the oven. Your installation must be protected by a 16 Amp thermal fuse. â· It is mandatory to use a power point with a ground terminal, connected in accordance with current safety regulations. [. . . ] Once the cooking program has been set, the DEPART key is not pressed in five minute, the setting will be cancelled. To do this, handle it by the access zones provided for this purpose. If you remove the turning gear, do not let water penetrate into the the motor axle hole. Don't forget to return the turning gear, wheel guide and turntable. [. . . ]