User manual BRAUN 1008

[. . . ] Our products are engineered to meet the highest standards of quality, functionality and design. We hope you thoroughly enjoy your new Braun appliance. important Keep the shaver and the mains lead dry at all times. [. . . ] important: After every shave replace the foil protection cap 7 on the foil frame 6. Cleaning and maintenance After every shave, remove the foil frame 6 (e) and tap out lightly. Brush out the cutter block 5 with the cleaning brush 8 (f). Do not clean the shaving foil 6 with the cleaning brush to avoid damaging it. Approximately every four weeks clean the space between the longhair trimmer 4 and the shaver with the cleaning brush 8. Clean the cutter block 5 with Braun cleaning spray to maintain your shaver's top shaving performance and to keep it hygienic. after every cleaning replace the foil protection cap 7 on the foil frame 6. Changing the shaving parts The shaving foil frame 6 should be held at the two grooved surfaces and pulled off (e). For cleaning) by turning it at right angles to the shaver and lifting it off (g). To replace the cutter block, snap it onto the holding studs (h). Replace the new foil frame in the right direction (e) until it locks in place. Important Buy only original Braun spare parts, especially when replacing the mains lead or the shaving foil frame 6. When buying a new shaving foil frame look for the brand and the correct identification number 596 (i). Only this way you can be assured of a safe, close and efficient shave. [. . . ] Year of manufacture: To determine the year of manufacture, refer to the 3-digit production code located at the lower side part of the handle. The first digit of the production code refers to the last digit of the year of manufacture. The next two digits refer to the calendar week in the year of the manufacture. [. . . ]