User manual BRAUN 320S-4

[. . . ] This appliance is provided with a special cord set with integrated Safety Extra Low Voltage power supply. Do not exchange or manipulate any part of it. Do not use an extension cord with this appliance. Close supervision is necessary when this appliance is used by, on, or near children or persons with disabilities. [. . . ] Long hair trimmer To trim sideburns, moustache or beard, slide the long hair trimmer (2) upwards. Under the nose) slide the switch (3) to the right to position . the center trimmer and one foil will be lowered. Tips for the perfect dry shave For best results, Braun recommends you follow 3 simple steps: 1. At all times, hold the shaver at right angles (90°) to your skin. Stretch your skin and shave against the direction of your beard growth. Cleaning The hand-held unit should be detached from the power supply cord before cleaning. The shaver should not be used until it has dried. regular cleaning ensures better shaving performance. Rinsing the shaver head under running water after each shave is an easy and fast way to keep it clean: • Switch the shaver on (cordless) and rinse the shaver head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. €¢ Next, switch off the shaver, remove the shaver Foil & Cutter cassette (1) and let it dry. €¢ If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer (2) and shaver Foil & Cutter cassette (1) (picture). 13 16:03 Alternatively, you may clean the shaver using a brush: • Switch off the shaver. Remove the shaver Foil & Cutter cassette and tap it out on a flat surface (picture). €¢ Using a brush, clean the inner area of the shaver head. However, do not clean the shaver Foil & Cutter cassette with a brush as this may damage it (picture). Keeping your shaver in top shape Replacement light for shaving parts To maintain the appliance performing like new, replace the shaver Foil & Cutter cassette (1), when the replacement light for shaving parts (7) comes on (after about 18 months) or when worn. Foil & Cutter cassette: 32S/32B The replacement light will remind you during the next 7 shaves to replace the Foil & Cutter cassette. Then the shaver will automatically reset the display. After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for at least 5 seconds to reset the counter. [. . . ] Please call 1-800-Braun 11 (800-272-8611) to be referred to the authorized Braun Service Center closest to you. This warranty does not cover foil and cutter cassette or damage resulting from accident, misuse, abuse, dirt, water, tampering, unreasonable use, normal wear, servicing performed or attempted by unauthorized service agencies or failure to provide reasonable and necessary maintenance, including recharging. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other legal rights which vary from state to state. [. . . ]