User manual BRAUN 3614

[. . . ] Do not use while bathing or in a shower. Do not place, store or charge the appliance where it can fall or be pulled into a tub or sink. Do not place in or drop into water or other liquid. Except when charging, always unplug this appliance from the electrical outlet immediately after using. [. . . ] Always attach plug to appliance first, then to outlet. To disconnect, turn all controls to «off», then remove plug from outlet. 1 2 2a 2b 3 Foil protection cap Shaving frame Shaving foil Floating cutter Cutter block 4 5 6 7 8 Release button Pop-out long hair trimmer Switch Charging light Shaver socket For the 3 first chargings: Plug the shaver into an electrical outlet and charge it for at least 16 hours (switch position «off»). The charging light (7) illuminates when the shaver is plugged in. Then shave without the cord until it runs distinctly slower. To activate it, press the red button and push the switch up: on = Combination shave (simultaneous use of floating cutter and shaving foil). The floating cutter cuts longer beard hairs or curly «problem hairs», the foil follows to give a close, smooth shave (b). We recommend that you shave before washing, as the skin tends to be slightly swollen after washing. Stretch your skin and shave against the direction of beard growth. ⷠReplace the shaving foil and cutter block every 1 1/2 years, or when the parts are worn, to ensure optimum shaving performance. Press the release buttons, take off the shaving frame (d) and gently tap it out on a flat surface (e). Then thoroughly clean the cutter block with the brush (f). About every four weeks, clean the cutter block with Braun cleaning agents (g). Do not clean the shaving foil with the brush. If you have a very dry skin and you notice a reduced operation time of the shaver, you should put a drop of sewing machine oil onto the cutting parts of the shaving frame (g). To maintain optimum shaving performance, we recommend to replace the shaving frame and the cutter block every 1 1/2 years or when these parts are worn. Press the release buttons, take off the shaving frame. Replace the new shaving frame in the right direction until it locks in place. To remove the cutter block, lift it off (g). To replace the cutter block, snap onto the holding studs. [. . . ] This warranty gives you specific legal rights, and you may also have other legal rights which vary from state to state. In the event a Braun Shaver fails to function within 2 years from date of purchase, because of defects in material or workmanship, and the consumer returns the unit to an authorized service center, Braun Canada will, at its option, either repair or replace the unit without additional charge to the consumer. This guarantee does not cover any product which has been damaged by dropping, tampering, wrong current, servicing performed or attempted by unauthorized service agencies, misuse or abuse, kinks in the shaving foil as well as the normal wear of the shearing parts. exclusion of Warranties: The foregoing warranty is the sole warranty offered by Braun Canada. [. . . ]