User manual BRAUN 5040WD

[. . . ] 12 15:13 English Our products are designed to meet the highest standards of quality, functionality and design. Thank you for your trust in Braun’s quality and we hope you enjoy your new Braun shaver. Please read the use instructions carefully and completely before using the appliance. Warning Your appliance is provided with a special cord set, which has an integrated Safety Extra Low Voltage power supply. [. . . ] Warning: Detach the shaver from the power supply before cleaning it in water. € Switch the shaver on (cordless) and rinse the shaver head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. € Next, switch off the shaver, press the release button (2) to remove the Foil & Cutter cassette (1) and let it dry. € If you regularly clean the shaver under water, then once a week apply a drop of light machine oil on top of the Foil & Cutter cassette. Alternatively, you may clean the shaver using the brush provided: • Switch off the shaver. Remove the Foil & Cutter cassette (1) and tap it out on a flat surface. 12 15:13 Cleaning programs 5090cc: The hygiene status will be analyzed and one of the following program indicators will light up. « » short economical cleaning required « » normal level of cleaning required « » high intensive cleaning required 5070cc/5050cc: One standard cleaning program included. Start automatic cleaning Start the cleaning process by pressing the start button (16). If status light (15a) does not shine (Clean&Charge Station switches to stand-by after ca. 10 minutes) , press start button twice. For best shaving results, we recommend cleaning after each shave. Each cleaning program consists of several cycles, where cleaning fluid is flushed through the shaver head. Depending on your Clean&Charge Station model and/or program selected, the cleaning time takes up to 3 minutes. During this time the status light blinks. Leave the shaver in the station for drying. It takes several hours until remaining moisture evaporates depending on the climatic conditions. After completing the cleaning and charging procedure, all indicators turn off. Removing the shaver from the Clean&Charge Station (see fig. E) Hold the Clean&Charge Station with one hand and tilt the shaver slightly to the front to release it. [. . . ] You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benefits given by this warranty are in addition to other rights and remedies of the consumer law. Com Our Warranty This appliance is also covered by a 24 Month Replacement Warranty commencing on the date of purchase (Our Warranty). Our Warranty applies in all States and Territories of Australia and in New Zealand and is in addition to any mandatory statutory obligations imposed on Procter & Gamble Australia Pty. [. . . ]