User manual BRAUN 530

[. . . ] The iron must be used and rested on a stable surface. During ironing pauses, always place the iron upright on its heel rest and ensure that the heel rest is placed on a stable surface. Never immerse the iron in water or other liquids. Unplug it when leaving the room, even if only for a short time. [. . . ] The temperature pilot light (7) goes off, 1 Steam on/off For steam ironing, the temperature selector (6) must be set within the red range. press the steam button (3) to start the steam mode. Steam on steam off (model 540/530 only) Before attaching the Textile Protector (8) for the first time, iron approximately 2 minutes without the Textile Protector. The Braun Textile Protector protects delicate fabrics from heat damage and makes it possible to iron most dark fabrics without an intermediate cloth. To check the reaction of your fabrics before you start ironing, we recommend that you iron a small section of material on the reverse side. With the Protector, you are able to iron delicate fabrics with the temperature setting «· » or «max», so that you can use all steam functions your iron offers. After having attached the Textile Protector, wait about 1 1/2 minutes before you start ironing. With the steam button in its upper position (steam on), turn the steam regulator (3a) to adjust the steam quantity. This preconditions the textiles by «pre-steaming», thus making ironing easier. Be careful ­ steam comes out laterally. 2 Power shot Prior to use, press the power shot button (5) 3 to 4 times to activate it. Press the power shot button in intervals of at least 5 seconds. Power shot can be activated when dry ironing. However, the temperature selector has to be set in the range between «· The power shot function can also be used in the vertical position for steaming hanging clothes. To prolong the life of the iron, empty the Store the cool iron in a dry place always Standing on its heel rest. To clean the sole plate, use steel wool. Then wipe the sole plate clean with a cloth. Never use a scouring pad, vinegar nor other chemicals. To clean the soft material of handle and power shot and spray buttons, use soapy water. 3) Remove carefully (some water may now leak from the sole plate). 6) Use a non-metallic brush until all openings are clean. Note: the iron must never be used without the steam button. [. . . ] Disconnect the iron and wait for the sole plate to cool off, then clean it as described above in section «G». 2 Extra ånga (Power shot) Innan strykjärnet används, tryck på Power shot knappen (5) 3 till 4 gånger för att aktivera den. 2 Power shot (parn ráz) Stlaãte tlaãidlo Power shot (5) 3 aÏ 4 krát pre jej aktiváciu v intervaloch najmenej 5 sekúnd. Within the guarantee period we will eliminate, free of charge, any defects in the appliance resulting from faults in materials or workmanship, either by repairing or replacing the complete appliance as we may choose. [. . . ]