User manual BRAUN 580CC

[. . . ] Close supervision is necessary when this appliance is used by, on, or near children or invalids. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or if the power supply has been dropped into water. [. . . ] While the shaver is drying, the metal parts of the shaver may be hot. Also, if the shaver is taken out prematurely and is not dry, its electronics could be harmed. When the program is finished, the blue «clean» light will shine. You can release the shaver by pushing the «start cleaning» button. Your shaver is now clean and ready for use. If the shaver is locked into the Clean&RenewTM station, push the «start cleaning» button (2) to release the shaver and take it out. Switch positions off = (switch is locked) Press and push up the switch to operate the shaver on = Shaving with the pivoting head (the pivoting cutting system automatically adjusts to every contour of your face). Fix = Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e. It can take up to 14-21 days for your beard to adjust to the new shaving system. Shave before washing your face or taking a shower, as skin tends to swell after washing. The drier the skin, the closer the shaving results will be. Stretch the skin and shave against the direction of beard growth. To maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn. Shaving with the cord If the shaver is completely discharged and you do not have the time to recharge in the Clean&RenewTM station, you may also shave with the shaver connected to an electrical outlet. Automatic cleaning After each shave, return the shaver to the Clean&RenewTM station and proceed as described above in the section «Before shaving». All charging and cleaning needs are then taken care of. With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles. The hygienic cleaning solution cartridge contains alcohol which, once opened, will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks. Quick cleaning Press the foil release buttons (12) to lift the shaver foil (do not remove the foil completely). 5­10 seconds so that the shaved stubbles can fall out. Thorough manual cleaning Manual cleaning is recommended only when the Clean&RenewTM station is not available, e. [. . . ] This warranty does not cover foils, cutter blocks or damage resulting from accident, misuse, abuse, dirt, water, tampering, unreasonable use, normal wear, servicing performed or attempted by unauthorized service agencies or failure to provide reasonable and necessary maintenance, including recharging. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other legal rights which vary from state to state. 2 year limited warranty (foil and cutter block excluded) In the event a Braun Shaver fails to function within 2 years from date of purchase, because of defects in material or workmanship, and the consumer returns the unit to an authorized service center, Braun Canada, will, at its option, either repair or replace the unit without additional charge to the consumer. [. . . ]