User manual BRAUN 6610

[. . . ] The shaver is only charging when the green light is on. ⷠUsing the special cord set, connect the shaver to the mains and charge it for at least 8 hours (shaver and adapter might get warm). Once the shaver is completely charged, shave without the cord until fully discharged. However, the maximum battery capacity will only be reached after several charging/discharging cycles. [. . . ] Turning on the shaver («start»): The pivoting cutting system automatically adjusts to every contour of your face. Head lock: Shaving in difficult areas (e. How much Shaving Conditioner you want to apply depends on your type of skin: wet skin might require more Shaving Conditioner. You may want to try out different scale positions. Stretch your skin and shave against the direction of beard growth. ⷠTo maintain 100% shaving performance, replace your foil and cutter block every 18 months or when worn. Warning: Detach the hand-held part from the power supply before cleaning it in water. Daily cleaning After each shave, you should hold the shaver ­ turned on and with its foil frame attached ­ upside down under running hot water. General cleaning Occasionally you should, while the shaver is turned off, remove the foil frame, and, using the brush, clean the cutter block and the inner area of the shaver head. Replace foil frame, ensuring both sides click audibly into place. If not properly attached, Shaving Conditioner could leak. Note When cleaning under running water, water may condensate inside the shaver`s cartridge chamber. This has no effect on the shaver`s operation and will disappear after a while You should exchange it when in the course of time you feel that less Shaving Conditioner is applied. B) Lift old applicator at the notch on one side, then the other. D) Place new applicator on the foil frame, leaving a small gap. E) With both thumbs push applicator right and left until it clicks into place. F) Replace foil frame, ensuring both sides click audibly into place. Replacing the shaving parts To maintain 100% shaving performance, replace your foil and cutter block every 18 months or when worn. Change both parts at the same time for a closer shave with less skin irritation. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. [. . . ] When inserting a new cartridge, only remove the silver sealing foil. do not remove the transparent pull-out tag. Condensation will disappear after a while and has no effect on the shaver's operation. None, or too little Shaving Conditioner dispensed after longer use Skin is red or burns Shaver is connected to the mains, but is not charging (green LED does not light up) Shaving head does not swivel Cartridge cannot be removed Shaver is completely discharged Head lock activated Pull-out tag was accidentally removed from cartridge Differences in temperature when cleaning with water Are undertaken by unauthorised persons and if original Braun parts are not used. [. . . ]