User manual BRAUN 6620

[. . . ] However, the maximum battery capacity will only be reached after several charging/discharging cycles. The green charging light shows that the shaver is being charged. When the rechargeable battery is fully charged, the charging light goes off. If later on, the charging light comes on again, this indicates that the shaver is being recharged to maintain its full capacity. [. . . ] Preserving the cell unit In order to maintain the optimum capacity of the rechargeable battery, the shaver has to be fully discharged (by shaving) every 6 months approximately. then recharge the shaver to full capacity again. Do not expose the shaver to temperatures of more than 50 °C for longer periods of time. Shaving with the cord If the rechargeable battery is discharged, you may also shave with the shaver connected to the mains via the power supply cord set (if the shaver does not run immediately, turn it off and charge for approx. A) b) c) d) e) f) Disconnect the power supply cord from the shaver. If necessary, remove old cartridge by its pull-out tag. In that case a small loss of liquid might occur. While travelling, do not take an unsealed cartridge along nor leave one in the shaver. GlideControl allows you to choose the amount of Shaving Conditioner you want to apply («min»/«max»): When you raise the distancing bar (moving the scale to «min»), the applicator will have less contact with your skin and will apply less Shaving Conditioner. If you move the scale to «max», more Conditioner will be applied. Please be aware that, in order to optimally pre-condition your skin, during the first seconds somewhat more Conditioner will be applied. Change both parts at the same time for a closer shave with less skin irritation. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country. The empty cartridge of the Shaving Conditioner can be disposed in the household waste. Shaving Conditioner is leaking Foil frame replaced incorrectly Remove foil frame and attach once more, ensuring both sides click audibly into place. If needed, clean both foil frame and shaver head. Or Applicator replaced Place new applicator on the foil frame, incorrectly leaving a small gap. With both thumbs push applicator right and left until it clicks into place. Or Shaver was switched on with Do not switch on when foil frame is foil frame removed removed. Or Cartridge was removed immediately after use None, or too little Shaving Conditioner dispensed with new shaver No cartridge inserted or Sealing foil not removed from cartridge or Scale positioned at «min» Applicator clogged or Cartridge empty Skin is not used to Shaving Conditioner Do not remove cartridge immediately after use. Sensitive skin might require 1 to 2 weeks to get accustomed. [. . . ] If your skin shows signs of intolerance, discontinue using the Shaving Conditioner. Leave shaver connected to the mains, push start/stop button once. Shaver will be charging when green LED lights up. Use appropriate tool (flat-nose pliers) to pull out cartridge. [. . . ]