User manual BRAUN 7505

[. . . ] Close supervision is necessary when this appliance is used by, on, or near children or invalids. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer. The appliance should never be exposed to temperatures of less than 32 ºF / 0 ºC and more than 105 ºF/+ 40 ºC for longer than a few hours. [. . . ] Then recharge to full capacity again (subsequent charges will take about 1 hour). However, the maximum battery capacity will only be reached after several charging/discharging cycles. The pilot light shows that the shaver is plugged into the outlet properly. The green charging light shows that the shaver is being charged. When the rechargeable battery is fully charged, the charging light flashes or goes off. If later on, the charging light comes on again, this indicates that the shaver is being recharged to maintain its full capacity. Switch positions 0 = Off (switch is locked) Press and push up the switch to operate the shaver: 1 = Shaving with the pivoting head The pivoting cutting system automatically adjusts to every contour of your face 2 = Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e. Under the nose) 3 = The long hair trimmer is activated (for trimming sideburns, moustache and beard) Shaving with the cord If the rechargeable battery is discharged, you may also shave with the shaver plugged into the outlet via the special cord set. (If the shaver does not run immediately, charge it with the switch on position «0» for approx. It can take up to 14-21 days for your beard to adjust to the new shaving system. ⷠShave before washing your face or taking a shower, as skin tends to swell after washing. ⷠThe drier the skin, the closer the shaving results will be. Stretch your skin and shave against the direction of beard growth. ⷠTo maintain 100% shaving performance replace your foil and cutterblock every 18 month or when worn. Cleaning For easy cleaning after each shave, switch the shaver off. Press the release buttons to lift the shaver foil (do not remove the foil completely). 5-10 seconds so that the shaved stubbles can fall out. for a thorough cleaning (weekly) , remove the shaving foil and tap it out on a flat surface. Using the brush, clean the cutter block and the inner area of the pivoting head. If your skin is very dry and you notice a reduced operation time of the shaver, apply a drop of light machine oil onto the shaver foil. [. . . ] please call 1-800-Braun 11 (800-272-8611) to be referred to the authorized Braun Service Center closest to you. This warranty does not cover foils, cutter blocks or damage resulting from accident, misuse, abuse, dirt, water, tampering, unreasonable use, normal wear, servicing performed or attempted by unauthorized service agencies or failure to provide reasonable and necessary maintenance, including recharging. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other legal rights which vary from state to state. [. . . ]