User manual BRAUN 7630

[. . . ] However, the maximum battery capacity will only be reached after several charging/discharging cycles. Do not expose the shaver to temperatures of more than 50 °C for longer periods of time. The green charging light shows that the shaver is being charged. When the rechargeable battery is fully charged, the charging light flashes or goes off. [. . . ] If your skin is very dry and you notice a reduced operation time of the shaver, apply a drop of light machine oil onto the shaver foil. Replacing the shaving parts The shaver foil and cutter block are precision parts that, in time, are subject to wear. Replace your foil and cutter block every 18 months and get a 25% better shave. ) (* Overall evaluation from Braun users comparing their shave with new parts and those used for 18 months. This appliance is provided with nickel-hydride rechargeable batteries. To protect the environment, do not dispose of the appliance in the household waste at the end of its useful life. Open the housing as shown, remove and dispose of the batteries at your retail store or at appropriate collection sites according to national or local regulations. This product conforms to the EMC-Requirements as laid down by the Council Directive 89/336/EEC and to the Low Voltage Regulation (73/23 EEC). During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfills the lubrication needs of the shaver. important · Only use the low voltage adaptation system supplied with the shaver. ⷠIn order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface or use the wall holder (not included in all versions). Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed. ⷠDo not place the appliance in a mirror cabinet, nor store it over radiators, nor place it on polished or laquered surfaces. When cleaning the shaver, its protection cap should be removed. 12 13 14 15 16 17 Lift button for cartridge exchange Contact bow Release button Operation mode selector «clean» light: cleaning process indicator «charge» light: charging process indicator 18 «cartridge» light: cartridge replacement indicator 19 Cleaning cartridge Wall holder (not included in all versions) Mount the wall holder with plugs and screws to a smooth wall so that the standing surface for the Clean&Charge is horizontal. Only applies for cordless shavers: For the first charge of the shaver, connect the low voltage supply cord directly to the shaver, charge it for 4 hours and shave at least once. Only then can the shaver be cleaned or recharged in the Clean&Charge. If the rechargeable batteries are discharged, select the combined «clean» + «charge» programme rather than the «clean» programme alone. Carefully remove the lid from the cartridge. Slowly close the housing by pushing it down until it locks. Replacing the cartridge After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge. [. . . ] The hygienic cleaning solution cartridge contains alcohol which, once opened, will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approx. Clean the housing from time to time with a damp cloth, especially the opening where the shaver rests. Within the guarantee period we will eliminate, free of charge, any defects in the appliance resulting from faults in materials or workmanship, either by repairing or replacing the complete appliance as we may choose. [. . . ]