User manual BRAUN 790 CC-4

[. . . ] The cleaning cartridge contains a highly flammable liquid so keep it away from sources of ignition. do not expose to direct sunlight for long periods of time. Do not refill the cartridge and use only original Braun refill cartridges. Clean&Renew station 1 Cleaning fluid display 2 Lift button for cartridge exchange 3 Station-to-shaver contacts 4 Start button D Fast clean button 5 Cleaning program indicators 6 Station power socket 7 Cleaning cartridge Shaver 8 Foil & Cutter cassette 9 Cassette «release» button 0 Shaver head «lock» switch q Pop-out long hair trimmer 12 Prior to first use you must connect the shaver to an electrical outlet using the special cord set p or alternatively proceed as below. [. . . ] (6 dark segments are shown on each side when the battery is fully charged and the shaver is hygienically clean). When fully charged all 6 segments are shown. with decreasing charge the segments gradually disappear. Low charge indicator: The low charge indicator provided with a red frame blinks to indicate that the charge has dropped below 20%. When the shaver is being used, the hygiene segments will gradually disappear. Once the shaver is returned to the station, the system will automatically select the appropriate cleaning program and restore the segments to maximum hygiene. Given that rinsing the shaver under tap water is not as hygienic as the cleaning station, the hygiene segments will only restore themselves when the shaver has been cleaned in the Clean&Renew station. This may vary according to your beard growth. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. Personalizing your shaver With the (­) e and (+) r buttons you can choose the best setting for shaving different areas of your face and as per your specific needs. The different settings are indicated by the pilot light incorporated in the on/off switch w: White (for a thorough comfortable shave in sensitive areas of your face such as neck) When switching on next time, the last used setting will be activated. How to use Press the on/off switch w to operate the shaver: · The pivoting shaver head and floating foils automatically adjust to every contour of your face. Under the nose) slide the shaver head «lock» switch 0 to the back position to lock the pivoting head at an angle. At all times, hold the shaver at right angles (90°) to your skin. Stretch your skin and shave against the direction of your beard growth. Shaving with the cord If the shaver has run out of power (discharged), and you do not have the time to recharge it in the Clean&Renew station, you may also shave with the shaver connected to an electrical outlet via the special cord set. Automatic cleaning After each shave, return the shaver to the Clean&Renew station and proceed as described above in the section «Before shaving». All charging and cleaning needs are then automatically taken care of. With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles. The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks. The cleaning cartridge also contains lubricants, which may leave residual marks on the outer foil frame after cleaning. [. . . ] Replacing the Foil & Cutter cassette / reset To maintain 100% shaving performance, replace the Foil & Cutter cassette 8, when the replacement symbol lights up on the shaver display z (after about 18 months) or when cassette is worn. The replacement symbol will remind you during the next 7 shaves to replace the Foil & Cutter cassette. then the shaver will automatically reset the display. After you have replaced the Foil & Cutter cassette, use a ball-pen to push the reset button t for at least 3 seconds to reset the counter. [. . . ]