User manual BRAUN BS 7497

[. . . ] However, the maximum battery capacity will only be reached after several charging/discharging cycles. Do not expose the shaver to temperatures of more than 50 °C for longer periods of time. 7497/7640: When the rechargeable battery is fully charged, all five charging lights illuminate (20% per light), provided the shaver is connected to the mains or switched on. 7630/7511: The green charging light shows that the shaver is being charged. [. . . ] Manual cleaning For easy cleaning after each shave, switch the shaver off. Press the release buttons to lift the shaver foil (do not remove the foil completely). 5-10 seconds so that the shaved stubbles can fall out. Replacing the shaving parts The shaver foil and cutter block are precision parts that, in time, are subject to wear. Replace your foil and cutter block every 18 months and get a 25% better shave. (* Overall evaluation from Braun users comparing their shave with new parts and those used for 18 months. Available at your dealer or Braun Service Centres: Shaver foil and cutter block (part no. To protect the environment, do not dispose of the appliance in the household waste at the end of its useful life. Open the housing as shown, remove and dispose of the batteries at your retail store or at appropriate collection sites according to national or local regulations. This product conforms to the EMC-Requirements as laid down by the Council Directive 89/336/EEC and to the Low Voltage Regulation (73/23 EEC). During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfills the lubrication needs of the shaver. important · Only use the power supply cord set supplied with the shaver. ⷠIn order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface. Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed. ⷠDo not place the appliance in a mirror cabinet, nor store it over radiators, nor place it on polished or laquered surfaces. Power consumption: 3 W when cleaning 7 W when charging · Only applies for cordless shavers: For the first charge of the shaver, connect the power supply cord set directly to the shaver, charge it for 4 hours and shave at least once. Only then can the shaver be cleaned or recharged in the Braun Clean&Charge. Carefully remove the lid from the cartridge. Slowly close the housing by pushing it down until it locks. [. . . ] ⷠWhen the «cartridge» light starts flashing, the remaining fluid in the cartridge is sufficient for about 5 more cleaning cycles. When the «cartridge» light illuminates constantly, the cleaning function is locked and a new cartridge has to be installed. Only then, the next cleaning cycle can be started. ⷠA cleaning cartridge should be sufficient for about 30 cleaning cycles. [. . . ]