User manual BRAUN BS 8990

[. . . ] However, the maximum battery capacity will only be reached after several charging/discharging cycles. · Best environmental temperature range for charging is 15 °C to 35 °C. · When fully discharged, you may also shave with the shaver connected to the mains via the power supply cord set. 30 Keeping your shaver in top shape Cleaning indicator Your shaver should be cleaned daily in the Clean&Charge, and certainly when the yellow cleaning light shines constantly after shaving. [. . . ] If this is not done, the yellow light will go out after some time. The shaver`s electronics will then assume it has been cleaned manually and a new calculation of the the time when the next cleaning is required will be started. During the cleaning process in the Clean&Charge the yellow light will flash and go off after approx. Automatic cleaning Once the shaver is put into in the Clean&Charge, it is cleaned automatically (see separate instructions). Manual cleaning is recommended only when the Clean&Charge is not available, e. g. when travelling. Manual cleaning Remove the shaver foil (shaver head must be in central position) and, using the brush, clean the cutter block and the inner area of the shaver head. Do not clean the shaver foil with the brush. When cleaning the shaver under running water, make sure it is completely dry before putting it into the Clean&Charge. Replacing the shaving parts The shaver foil and cutter block are precision parts that, in time, are subject to wear. Replace your foil frame and cutter block every 18 months and get a 25% better shave. * (Shaver foil and cutter block: part no. F/C505, available at your dealer or Braun Service Centres). · Hold the cartridge down on a flat, stable surface (e. g. Carefully remove the lid from the cartridge. Slide the cartridge into the base as far as it will go. · Slowly close the housing by pushing it down until it locks. Replacing the cartridge After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution. The used cartridge can be disposed in the household waste. Operating your Clean&Charge · Connect your Clean&Charge with the cord set to the mains electricity supply. The special socket at the back is adjustable to save space. After each shave, switch the shaver off and put it into the Clean&Charge, upside down and with the front showing. · Push the start/release button (3) to lock and connect the shaver. The yellow light on the shaver will flash during the complete process (approx. [. . . ] The yellow light on the shaver will flash during the complete process (approx. · Do not interrupt the cleaning process, as it leaves the shaver wet and not fit for use. If interruption is needed nonetheless, press the start/release button button (3). · When cleaning is finished, the yellow light will go off and the shaver is ready for use. [. . . ]