User manual BRAUN BS 9781

[. . . ] Clean&Renew station 1 Cleaning fluid display 2 Lift button for cartridge exchange 3 Station-to-shaver contacts 4 «start cleaning» button 5 Cleaning program diodes 6 Station power socket 7 Cleaning cartridge Shaver 8 Foil & cutter cassette 9 Cassette release button 0 Shaver head «lock» switch q Pop-out long hair trimmer w On/off switch e Reset button r Shaver display t Shaver-to-station contacts z Shaver power socket u Travel case i Special cord set 22 Prior to first use you must connect the shaver to an electrical outlet using the special cord set i or alternatively proceed as below. installing the Clean&Renew station · Using the special cord set i, connect the station power socket 6 to an electrical outlet. Carefully remove the lid from the cartridge. Slowly close the housing by pushing it down until it locks. [. . . ] At all times, hold the shaver at right angles (90°) to your skin. Stretch your skin and shave against the direction of your beard growth. Shaving with the cord If the shaver has run out of power (discharged), and you do not have the time to recharge it in the Clean&Renew station, you may also shave with the shaver connected to an electrical outlet via the special cord set. Automatic cleaning After each shave, return the shaver to the Clean&Renew station and proceed as described above in the section «Before shaving». All charging and cleaning needs are then automatically taken care of. With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles. The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks. The cleaning cartridge also contains lubricates, which may leave residual marks on the outer foil frame after cleaning. However, these marks can be removed easily by wiping gently with a cloth or soft tissue paper. Manual cleaning The shaver head is suitable for cleaning under running tap water. Warning: Detach the shaver from the power supply before cleaning the shaver head in water. Rinsing the shaving head under running water is an alternative way to keep the shaver clean, especially when travelling. ⷠSwitch the shaver on (cordless) w and rinse the shaver head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. Next, switch off the shaver, press the release button 9 to remove the foil and cutter cassette 8 and let it dry. If you regularly clean the shaver under water, apply a drop of the light machine oil, included with the shaver, onto the shaver foil and long hair trimmer. This is critical for proper functioning of the shaver as washing under water can lead to removal of lubricants from the shaver's cutting parts leading to higher friction in the shaver. This may result in the battery running out faster than normal. [. . . ] In the interest of protecting the environment, please do not dispose of the product in household waste at the end of its useful life. Disposal can take place at a Braun Repair Centre or at appropriate collection points provided in your country. The cleaning cartridge can be disposed with regular household waste. Within the guarantee period we will eliminate, free of charge, any defects in the appliance resulting from faults in materials or workmanship, either by repairing or replacing the complete appliance as we may choose. [. . . ]