User manual BRAUN COOLTEC

[. . . ] We hope you are completely satisfied with your new Braun shaver. 12 16:06 English IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: Read all instructions before using this appliance. When disconnected, the hand-held part of this shaving appliance may be used in a bath or shower. For safety reasons, it can only be operated cordlessly. [. . . ] Long hair trimmer To trim sideburns, moustache or beard, press the release button (8) and slide the long hair trimmer (6) upwards. Travel lock • Activation: By pressing the on/off switch (5) for 3 seconds the shaver is locked. This is confirmed by a beep sound and the lock symbol in the display. €¢ Deactivation: By pressing the on/off switch for 3 seconds the shaver is unlocked again. €¢ In order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface. Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed. €¢ Do not place the appliance in a mirror cabinet, nor store it over radiators, nor place it on polished or lacquered surfaces. €¢ Keep out of reach of children. 13 14 15 16a 16b 17 18 Station power socket Lift button for cartridge exchange Station-to-shaver contacts Level indicator Status light Start button Cleaning cartridge Installing the Clean&Charge station (see fig. E) • Remove the protection foil from the Clean&Charge station display. €¢ Press the lift button (14) at the rear side of the Clean&Charge station to lift up the housing. €¢ Hold the cleaning cartridge (18) down on a flat, stable surface (e. €¢ Carefully remove the lid from the cartridge. €¢ Slide the cartridge from the rear side into the base of the station until it snaps into place. €¢ Slowly close the housing by pushing it down until it locks. €¢ Using the special cord set (10), connect the station power socket (13) to an electrical outlet. Charging the shaver in the Clean&Charge station Insert the shaver head down into the Clean&Charge station. Important: The shaver needs to be dry and free from any foam or soap residue!The contacts (7) on the back of the shaver need to align with the contacts (15) in the Clean&Charge station. Push the shaver in the correct position. A beep sound confirms that the shaver sits properly in the station. Cleaning the shaver in the Clean&Charge Station When the cleaning indicator lights up in the shaver display, insert the shaver into the Clean&Charge station, upside down and with the front showing. [. . . ] Include a copy of your proof of purchase to verify warranty coverage, if applicable. to obtain original Braun replacement parts & accessories: Contact a Braun Authorized Service Center. Please call 1-800-387-6657 to be referred to the Authorized Braun Service Center closest to you. To speak to a Braun Service Representative: Please call 1-800-387-6657. [. . . ]