User manual BRAUN COOLTECH CT2S

[. . . ] 12 10:42 English Our products are designed to meet the highest standards of quality, functionality and design. Thank you for your trust in Braun’s quality and we hope you enjoy your new Braun shaver. This shaver cools the skin to give you a cooling sensation for a pleasant shave. Please read the use instructions carefully and completely before using the appliance. [. . . ] You should be able to finish your shave with activated cooling function. You can deactivate the cooling function by pressing the cooling switch again. 12 Clean&Charge station (models CT6cc/CT5cc/CT4cc/CT3cc/CT2cc) The Clean&Charge station has been developed for cleaning, charging, lubricating, disinfecting and storing your Braun shaver. 13 14 15 16a 16b 17 18 Station power socket Lift button for cartridge exchange Station-to-shaver contacts Level indicator Status light Start button Cleaning cartridge Installing the Clean&Charge station (see fig. E) • Remove the protection foil from the Clean&Charge station display. € Press the lift button (14) at the rear side of the Clean&Charge station to lift up the housing. € Hold the cleaning cartridge (18) down on a flat, stable surface (e. 12 10:42 • Carefully remove the lid from the cartridge. € Slide the cartridge from the rear side into the base of the station until it snaps into place. € Slowly close the housing by pushing it down until it locks. € Using the special cord set (10), connect the station power socket (13) to an electrical outlet. Charging the shaver in the Clean&Charge station Insert the shaver head down into the Clean&Charge station. Important: The shaver needs to be dry and free from any foam or soap residue!The contacts (7) on the back of the shaver need to align with the contacts (15) in the Clean&Charge station. Push the shaver in the correct position. A beep sound confirms that the shaver sits properly in the station. The Clean&Charge station will automatically charge the shaver. Cleaning the shaver When the cleaning indicator lights up in the shaver display, insert the shaver into the Clean&Charge station, upside down and with the front showing. Start automatic cleaning Start the cleaning process by pressing the start button (17). If the status light (16b) does not shine (Clean&Charge station switches to stand-by after about 10 minutes), press the start button twice. For best shaving results, we recommend cleaning after each shave. The cleaning program consists of several cycles, where cleaning fluid is flushed through the shaver head. [. . . ] Or its distributors or manufacturer, whether at law, in tort (including negligence), in equity or under statute. Please retain proof of purchase of this appliance. If you have any questions in relation to Our Warranty, please call our Consumer Service line (see below for numbers). If you intend to make a claim please telephone our Customer Service line on the numbers set out below 15 For UK only: This guarantee in no way affects your rights under statutory law. [. . . ]