User manual BRAUN CRUZER 4 FACE

[. . . ] Oil bottle Keep out of reach of children. 1 2 3 4 4a 4b 5 6 7 Protective cap Shaver foil Cutter block Twistable trimmer Wide trimmer (28 mm) Narrow trimmer (14 mm) Charging light On/off switch Special cord set Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. ⷠUsing the special cord set, connect the shaver to an electrical outlet with the motor switched off. ⷠWhen charging for the first time or when the shaver is not used for a few months, leave the shaver to charge continuously for 4 hours. [. . . ] The wide trimmer is provided with safety rips and a gliding strip for less irritation and easy gliding. Press the blue stripes to push up the twistable trimmer (4). While stretching the skin, guide the wide trimmer against the direction of hair growth. The narrow trimmer (4b) precisely defines lines and edges (d), being ideal for precise contouring. To use the narrow trimmer, push up the twistable trimmer and turn it 180°. The shaver head is suitable for cleaning under running tap water. Warning: Detach the shaver from the power supply before cleaning the shaver head in water. Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean: · Switch the shaver on (cordless) and rinse the shaving head under hot running water (e). You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. ⷠNext, switch off the shaver, remove the shaver foil and the cutter block. Then leave the disassembled shaving parts to dry. ⷠIf you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the trimmers (4a, 4b) and shaver foil (f). Alternatively, you may clean the shaver using the brush provided (g): · Using the brush, clean the cutter block and the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil. Replacing the shaving parts To maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn. Change both parts at the same time for a closer shave with less skin irritation. (Shaver foil and cutter block: 10B) Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country. Within the guarantee period we will eliminate any defects in the appliance resulting from faults in materials or workmanship, free of charge either by repairing or replacing the complete appliance at our discretion. This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. [. . . ] Young children should be supervised to ensure that they do not play with the appliance. If the appliance is powered by a cord extension set or electrical portable outlet device these should be positioned so they are not subject to splashing or ingress of moisture. To the extent permitted by the laws of the Commonwealth of Australia and New Zealand and applicable laws of a State or Territory of Australia, and subject to the second paragraph of this warranty above, this warranty is given in exchange for any other rights you may have against Procter & Gamble Australia Pty. Or its distributors or manufacturer, whether at law, in tort (including negligence), in equity or under statute. [. . . ]