User manual BRAUN CRUZER 6 CLEAN SHAVE W&D

[. . . ] For hygienic reasons, do not share this appliance with other persons. Oil bottle Keep out of reach of children. Description 1 2 3 4 4a 4b 5 6 7 8 9 10 11 3-day beard comb & protective cap Shaver foil Cutter block Twistable trimmer Wide trimmer (28 mm) Narrow trimmer (14 mm) Charging light On/off switch Adjustable comb Beard length selector Special cord set Precision comb Charging stand Charging The best environmental temperature for charging is between 15 °C and 35 °C. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. [. . . ] Turn on the shaver and use the appliance as shown in the illustration (e). the attachment ensures an optimum usage angle. Adjustable comb (7): This attachment is ideal for beard trimming and keeping it at a constant length. € Place the attachment onto the shaver foil (2) and set desired beard length. € Press the on/off switch and trim against hair growth by guiding the transparent comb part over the skin (f). € It is recommended to place the 3-day beard comb & protection cap (1) onto the shaving foil (2) (e) when using the precision comb. € Place the attachment onto the extended narrow trimmer (4b) (g). € Turn on the shaver and trim against hair growth (g). Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean: • Switch the shaver on (cordless) and rinse the shaving head under hot running water (h). You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. € Next, switch off the shaver, remove the shaver foil and the cutter block. Then leave the disassembled shaving parts to dry. € If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the trimmers (4a, 4b) and shaver foil (i). Alternatively, you may clean the shaver using the brush provided (j): • Switch off the shaver. € Using the brush, clean the cutter block and the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil. Keeping your shaver in top shape Replacing the shaving parts To maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn. Change both parts at the same time for a closer shave with less skin irritation. (Shaver foil and cutter block: 10B) Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. Then recharge the shaver to full capacity. environmental notice This product contains rechargeable batteries. [. . . ] If you have any questions in relation to Our Warranty, please call our Consumer Service line (see below for numbers). If you intend to make a claim please telephone our Customer Service line on the numbers set out below to obtain information about your claim and any costs associated with claiming under Our Warranty. You will bear the cost of returning your product to us. Repairs and service If you are sending your appliance for repair under Our Warranty, please pack the appliance adequately and send it to your nearest Service Agent, at your expense. [. . . ]