User manual BRAUN CRUZER2 QUICKSTART

[. . . ] Do not exchange or manipulate any part of it. Otherwise there is risk of electric shock. 1 2 3 4 4a 4b 5 6 7 Foil protection cap Shaver foil Cutter block Styler Wide shaper (28 mm) Narrow shaper (14 mm) Charging light On/off switch Special cord set Using the special cord set, connect the shaver to an electrical outlet with the motor switched off. [. . . ] For pre-shaving after a few days of not having shaved, use the wide shaper (4a) to pre-cut long hairs. For a close, smooth shave, finish with the foil. We recommend that you shave before washing, as the skin tends to be slightly swollen after washing. Stretch the skin and shave against the direction of beard growth. ⷠTo maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn. Press the blue rib to push out the styler (4). the narrow shaper (4b) precisely defines lines and edges (d): Ideal for precise contouring. To use the narrow shaper, push out the styler and turn it 180°. Frequent use of the styler may reduce the battery capacity. Warning: Detach the hand-held part from the power supply before cleaning it in water. regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean: · Switch the shaver on (cordless) and rinse the shaving head under hot running water (e). A natural based soap may also be used provided it contains no particles or abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. [. . . ] (Shaver foil and cutter block: 2000 series) Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. then recharge the shaver to full capacity. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. [. . . ]