User manual BRAUN J500

[. . . ] € Before use, always check the entire appliance, in particular the filter for damage (cracks, flaws). Do not use if the cord or any part of the appliance – esp. € Do not bring the power cord into contact with hot parts, do not pull it over sharp edges or carry the appliance by the power cord. € Protect the motor part and the power cord against humidity. [. . . ] Rhubarb, fruits that contain starch (bananas, mangoes, papayas, avocados and figs), very hard and fibrous fruits or vegetables • Put fruits or vegetables into the filling shaft (8) (fig. € Turn the switch (2) to position «I» or «II»: • Press slightly with the pusher (9) (fig. Add more fruits or vegetables while the motor is running. € The amount of juice you extract depends on the nature of the fruits and vegetables. € Fruit and vegetable juices contain valuable vitamins and minerals, which quickly deteriorate when they come into contact with oxygen or light. Drink juice fresh – right after it has been extracted. Emptying the pulp container and filter Pulp container (4): As soon as the pulp container looks full turn off the appliance, unplug it and empty the pulp container. Filter (6): If the juice suddenly becomes much thicker, if larger amounts of pulp get stuck between filter and lid and/or if you can hear the motor speed slow down, the filter and juice collector must be emptied and cleaned (see «Disassembling »). Empty the pulp container and assemble the appliance again. Extracting juice • Important: Use only well ripened fruits otherwise the filter (6) may be clogged up. € Before use, always unwind the power cord completely from the cord storage (14). € Fruits/vegetables need to be washed if they will be processed unpeeled. Apples, pears, carrots, beets Preparation Remove uneatable peel Process seed fruits with cores Processing Position II Drip stop feature (only model J700/J500) When the juice spout (10a) is in a tilted position it functions as a drip stop and collects the dripping juice: Turn the appliance off, wait for a few seconds until the juice only drips from the appliance. Then push the spout (10a) to the tilted position (fig. Cabbage, together tightly spinach or herbs before processing Position II Disassembling 1. Switch off the appliance by turning the switch (2) to position « O » and unplug it (fig. Model J700/J500: Put juice spout (10a) in upright position to allow remaining juice to drain off. Release the clamps to unlock the lid (fig. Slide rests of pulp from juice collector into the pulp container. Remove the juice collector (5) together with the filter (6). Take the filter out of the juice collector (fig. Remove the juice spout (10a/10b) by pressing on both sides with thumb and forefinger at the check marks (fig. [. . . ] Stop is activated Only activate drip stop, when juice drips from the appliance. 6 7 8 9 10a Filter Deksel Vul as stamper Sap uitloop met druppelstop-functie (alleen model J700/J500) 10b Sap uitloop (alleen model J300) 11 Sap deksel op 12 Foam scheidingsteken 13 Sapkan 14 Snoeropbergmogelijkheid 15 Schoonmaak borsteltje Voordat u voor de eerste keer wast, was de afneembare fruitpers delen (zie «Demontage» en «Schoonmaken»). Position for at give resterende saft mulighed for at løbe ud. Inden for garantiperioden vil Braun for egen regning afhjælpe fabrikations- og materialefejl efter vort skøn gennem reparation eller ombytning af apparatet. [. . . ]