User manual BRAUN K3000

[. . . ] 1 2 3 4 5 Lid with filling tube and pusher Protective cover Universal blade Food processor bowl Discs Ö French fries disc Ü Julienne disc á Reversible slicing disc à Reversible shredding disc â Grating disc ä Disc carrier Protective cover 2 Before use, remove the plastic cover by standing the universal blade with the cover on the table and pressing the knob downwards until the protective cover loosens (A). The universal blade can only be placed into the food processor bowl 4 without its cover (B). After use, replace the cover by standing the universal blade on the table. The symbol on the cover must be over the higher part of the universal blade. [. . . ] When adding ingredients through the filling tube (G), always use the pusher. Never reach into the filling tube when the motor is running. Discs Ö, Ü, á: For the most even results, push the food to be processed into the filling tube when the appliance is switched off. Discs à, â: Food can be pushed into the filling tube while the motor is running. Processed at speed 2–7, hard foods can be shredded at a speed up to 14. Disassembling and assembling Lid For cleaning, remove the seal from the inside of the lid. Please replace the dry seal so that the plastic clips in the lid fit into the groove of the seal (H). Grating disc â Speed 7–14 The writing must be facing the user. , for potato pancakes), horseradish, parmigiano cheese (hard). Remove the blade from the goblet by taking hold of the knob and, while pressing down with your thumb, pulling it off the drive shaft (I). To insert the blade into the goblet, press it onto the drive shaft until it clicks. glass liquidiser goblet 8 Remove the blade as described above. To disassemble the goblet (J), first turn it upside down, reach into it with one hand and hold the plastic base of the drive shaft. Then, using the pusher, unscrew the fastening of the bottom by turning anti-clockwise (D). Take off the screw fastening (a), the plastic ring (b) and the goblet (c) one after the other, so that finally, you only hold the drive shaft (e) with bottom and seal (d) in your hand. To re-assemble, please proceed in the reverse order (K): Place the seal onto the lower side of the drive shaft bottom. Turn the goblet upside down and place the opening in the goblet bottom over the seal on the drive shaft bottom. Please, be careful not to dislocate the seal. Place the plastic ring (b) onto the goblet bottom so that the projection on the plastic ring engages with the groove in the bottom of the goblet (next to handle). Fasten all of these parts by turning the screw fastening (a) clockwise by means of the pusher. Glass liquidiser goblet Use the glass liquidiser goblet 8 for mixing, chopping and cutting small quantities. french fries disc Ö Speed 2–7 Caution! [. . . ] Hot foods can also be blended in this heatresistant goblet. Baby food remains warmer if the glass liquidiser goblet is warmed with hot water beforehand. Pulse Reversible shredding disc à Speed 2–14 This disc can be used from both sides (coarse/ fine). , cucumbers) should be Parsley, garlic, onions or nuts can be chopped, as well as hard bread rolls for bread-crumbing and meat. [. . . ]