User manual BRAUN SERIE 7

[. . . ] This appliance is not intended for use by children or persons with reduced physical or mental capabilities, unless they are given supervision by a person responsible for their safety. In general, we recommend that you keep the appliance out of reach of children. To prevent the cleaning fluid from leaking, ensure that the Clean&Renew station is placed on a flat surface. When a cleaning cartridge is installed, do not tip, move suddenly or transport the station in any way as cleaning fluid might spill out of the cartridge. [. . . ] With decreasing charge the segments gradually disappear. Low charge indicator: The low charge segment provided with a red frame blinks to indicate that the charge has dropped below 20%. The remaining capacity is sufficient for 2 to 3 shaves. 2008 14:33:50 Uhr Hygiene segments: All 6 hygiene segments will appear after the shaver has been cleaned in the Clean&Renew station. When the shaver is being used, the hygiene segments will gradually disappear. Once the shaver is returned to the station, the system will automatically select the appropriate cleaning program and restore the segments to maximum hygiene. Given that rinsing the shaver under tap water is not as hygienic as the cleaning station, the hygiene segments will only restore themselves when the shaver has been cleaned in the Clean&Renew station. charging information • A full charge provides up to 50 minutes of cordless shaving time. This may vary according to your beard growth. € The best environmental temperature for charging is between 5 °C to 35 °C. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. Remove the foil and cutter cassette 8 and tap it out on a flat surface. Using the brush, clean the inner area of the pivoting head. However, do not clean the cassette with the brush as this may damage it. Cleaning the housing From time to time clean the housing of the shaver and the Clean&Renew station with a damp cloth, especially inside the cleaning chamber where the shaver rests. Replacing the cleaning cartridge After having pressed the lift button 2 to open the housing, wait for a few seconds before removing the used cartridge to avoid any dripping. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution. Release release washable release washable washable new old Keeping your shaver in top shape Replacing the foil and cutter cassette / reset To maintain 100% shaving performance, replace the foil and cutter cassette 8, when the replacement symbol lights up on the shaver display r (after about 18 months) or when cassette is worn. The replacement symbol will remind you during the next 7 shaves to replace the foil and cutter cassette. Then the shaver will automatically reset the display. After you have replaced the foil and cutter cassette, use a ball-pen to push the reset button e for at least 3 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. [. . . ] To obtain service within the guarantee period, hand in or send the complete appliance with your sales receipt to an authorised Braun Customer Service Centre. For UK only: This guarantee in no way affects your rights under statutory law. Clean eco norm al auto sel intens ive ect st a rt cleaning clean eco al norm fast clea n inten auto sive ct high low empty sele 1 2 fast clean new • Posez la cartouche de nettoyage 7 à plat sur une surface stable et plane (par exemple une table). Clean st a rt cleaning clean eco norm n al fast clea high low empty intens auto ive st a rt cleaning eco l norma n t selec fast clea high low empty intens auto ive t selec • Retirez délicatement le couvercle de la cartouche. [. . . ]