User manual BRAUN SERIES 3 3045 WET&DRY

[. . . ] This appliance is provided with a special cord set with integrated Safety Extra Low Voltage power supply. Do not exchange or manipulate any part of it. Do not use an extension cord with this appliance. Close supervision is necessary when this appliance is used by, on, or near children or persons with disabilities. [. . . ] Tips for a perfect dry shave For best results, Braun recommends that you follow 3 simple steps: 1. At all times, hold the shaver at right angles (90°) to your skin. Stretch your skin and shave against the direction of your beard growth. cleaning Regular cleaning ensures better shaving performance. Cleaning under running water: • Switch the shaver on (cordless). Rinse the shaver head and the precision mode switch under hot running water until all residues have been removed. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. €¢ Next, switch off the shaver, remove the Foil & Cutter cassette (1) and let it dry. €¢ If you regularly clean the shaver under water, then once a week apply a drop of light machine oil (not included) onto the long hair trimmer (2) and Foil & Cutter cassette (1). The shaver should be cleaned after each foam usage. Cleaning with a brush: • Switch off the shaver. Remove the Foil & Cutter cassette and tap it out on a flat surface. €¢ Using a brush, clean the inner area of the shaver head. However, do not clean the Foil & Cutter cassette with a brush as this may damage it. Keeping your shaver in top shape Replacement light for shaving parts / Reset To maintain 100% shaving performance, replace the Foil & Cutter cassette (1), when the replacement light for shaving parts (7) comes on after about 18 months or when worn. The replacement light will remind you during the next 7 shaves to replace the Foil & Cutter cassette. Then the shaver will automatically reset the display. After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for at least 5 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. The manual reset can be done at any time. 15 11:47 PROVED Effective Date 17Jul2015 GMT - Printed 04Aug2015 Pag Accessories Foil & Cutter cassette: 32S/32B Styling attachment for Series 3 shavers*: BT32 * Fits all Series 3 shavers with Foil & Cutter cassette 32S/32B (Types 5416/5415/5414/5413/5412/5411) Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged by shaving every 6 months approximately. [. . . ] Please call 1-800-Braun 11 (800-272-8611) to be referred to the authorized Braun Service Center closest to you. This warranty does not cover foil and cutter cassette or damage resulting from accident, misuse, abuse, dirt, water, tampering, unreasonable use, normal wear, servicing performed or attempted by unauthorized service agencies or failure to provide reasonable and necessary maintenance, including recharging. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other legal rights which vary from state to state. [. . . ]