User manual BREIL OS80

[. . . ] In order to be able to make full use of the guarantee service (subject to the guarantee terms), please ensure that the Breil international guarantee card is supplied with the watch at the time of purchase. Stopwatch second hand Minute hand Alarm hand Continuous second hand or stopwatch 1/20 second hand Alarm on/off hand Stopwatch hour hand Hour hand Stopwatch minute hand Button Button Button Crown The time is indicated by the hour, minute and small second hands. the date is indicated by the numeral shown in the calendar window. The stopwatch can measure up to 12 hours in 1/20 second increments. [. . . ] Unscrew the crown and pull it all the way out (second click). The hands move quickly if the button or are kept pressed. Once the hands have been reset, set the time again, then push the crown back in to normal position and screw it in. Press button to check that the stopwatch hands go back to "0". The tachymeter is used to measure the speed of a vehicle. By knowing how many seconds it takes the vehicle to travel one kilometre, the tachymeter can measure the approximate average speed in km/h during a journey (over a maximum measurable time of 60 seconds). If the chronograph is started at the same time as the start of the distance measurement and stopped after one kilometre, the average speed can be calculated from the position of the second hand. If the vehicle covers a distance of one kilometre in 45 seconds, then the approximate average speed is 80 km/h. - In order to prevent water coming into contact with the internal mechanism, never pull the crown out when the watch is wet. - If any watches designed for sportswear or use in water come into contact with salt water or heavy sweating, they should be rinsed in fresh water and dried thoroughly. Must be kept away from water and moisture Average water resistance. Can withstand spray, sweat, light rain, washing, etc. During daily use Can be worn while swimming but not diving Suitable for skin-diving. * Always keep the crown in its normal position. - Contact with water may cause a deterioration in the quality of some leather straps. - As internal parts of the watch can retain moisture, when the outside temperature is lower than the inside, the watch glass may mist-up. This phenomenon is purely temporary and should not create any problems. However, if it persists for any length of time, the watch should be checked by the shop where it was purchased or by the nearest Authorised Service Centre. Temperature Do not leave the watch exposed to direct sunlight or temperature extremes for long periods of time. Long exposure, in fact, may adversely affect the operation of the watch and actually shorten battery life, causing it to gain or lose time and affect its other functions. [. . . ] cleaning the watch strap: · Metal bands: use a toothbrush and soapy warm to wash the dirt off. Leather straps: gently rub the face of the strap using a soft dry cloth. Clean the opposite side with a cloth and alcohol. Periodic inspection In order to guarantee long trouble-free operation, it is advisable to have the watch checked by an Authorised Assistance Centre once every two years. [. . . ]