User manual BREIL VD57

[. . . ] Otherwise, the date may not change properly. Pull out the crown to the second click when the second hand is at the 12 o'clock positon. Turn the crown clockwise until the desired date appears, and set the hour and minute hands to the desired time. ⷠWhen setting the hour hand, be sure to check that AM/PM is correctly set. [. . . ] press "A" repeatedly to reset the chronograph 1/10 second hand to the "0" position. Press "B" repeatedly to reset the chronograph second and minute hands to the "0" position. ⷠThe chronograph minute hand moves correspondingly with the chronograph second hand · The hands move quickly if the respective buttons are kept pressed 3. Push the crown back in to the normal position. When the battery is replaced, the time information stored in the built-in IC and the time indicated by the hands do not correspond with each other. Before using the watch, therefore, be sure to reset the hands to the "0" position, following the procedure below. ⷠIn case any of the hands should move improperly, follow the procedure below to adjust the hand movement. Keep "A" and "B" pressed at the same time for 2 seconds, and then release the buttons. The chronograph second hand turns half a circle counterclockwise and the returns where it was. The chronograph 1/10 second hand turns a full circle clockwise and stops. Press "B" repeatedly to reset the chronograph second and minute hands to the "0" position · the "0" position of the chronograph 1/10 second differs depending on the models. (Some models have the "0" position of the chronograph 1/10 second hand at 3 and 9 o'clock sides at the small dial. In that case, check if the hand is level with its both ends pointing to those "0" positions) · The chronograph minute hand moves correspondingly with the chronograph second hand. ⷠThe hands move quickly if the respective buttons are kept pressed. Turn the crown clockwise or counterclockwise to set the hour and minute hands to the desired time. (For details , refer to "TIME/CALENDAR SETTING") 5. Push the crown back in to the normal position. - In order to prevent water coming into contact with the internal mechanism, never pull the crown out when the watch is wet. - If any watches designed for sportswear or use in water come into contact with salt water or heavy sweating, they should be rinsed in fresh water and dried thoroughly. Must be kept away from water and moisture Average water resistance. Can withstand spray, sweat, light rain, washing, etc. During daily use Can be worn while swimming but not diving Suitable for skin-diving. [. . . ] The watch case and strap may discolour if they come into contact with mercury from a broken thermometer or other equipment. Keeping the watch clean Use an absorbent soft cloth to clean off any dirt or damp from the watch glass. Wearing the watch when the strap or back of the case is dirty can cause skin irritation. cleaning the watch strap: · Metal bands: use a toothbrush and soapy warm to wash the dirt off. [. . . ]