User manual BREVILLE 800CP

[. . . ] · Always use the Citrus Press on a dry, level surface. · Remove any promotional stickers before using the Citrus Press. · Always make sure the Citrus Press is properly assembled before connecting the plug and switching on at the power outlet and switching ON the On/Off button on the appliance. The appliance will not operate unless properly assembled. [. . . ] Use the Coarse Filter for maximum pulp content in the juice and the Fine Filter to decrease the pulp content in the juice. Step 4. Place the Juicing Cone onto the Drive Shaft and press down lightly to lock the Cone into position. Step 5. Insert the Fruit Dome onto the underside of the Juicing Press Arm by aligning the tab on top of the Fruit Dome with the hole in the Juicing Press Arm. Hold onto the Juicing Press Arm and press the Fruit Dome up and backwards until the Dome locks into position. Note: The Fruit Dome is keyed, and can only be inserted in one way (this will ensure that it does not rotate through operation). Step 6. Ensure the Anti-drip Juice Spout is pushed down into the pouring position. Place a suitable sized glass or jug underneath the Juice Spout. 8 ASSEMBLING YOUR BREVILLE 800 CLASS CITRUS PRESS ASSEMBLING YOUR BREVILLE 800 CLASS CITRUS PRESS 9 OPERATING YOUR BREVILLE 800 CLASSTM CITRUS PRESS Step 1. Ensure the 800 Class Citrus Press is correctly assembled and a glass or jug is placed under the Juice Spout before juicing commences. Step 2. Cut the citrus fruit in half by cutting across the fruit segments, rather than across the tip ends, to ensure more efficient juicing. Important: Some fruits, such as lemons and tangelos, have knobbly tip ends which require trimming for better contact with the Fruit Dome. Operating Step 3. Plug the power cord into a 230/240v power outlet, switch on at the power outlet then switch the On/Off button to ON. Turn machine main switch `On'. OPERATING YOUR BREVILLE 800 CLASS CITRUS PRESS 11 NOTE: The Stainless Steel Filter should be emptied when full with pulp and seeds. The Filter can be emptied during juicing by switching the Citrus Press "OFF" at the On/Off button and carefully removing the Juicing Cone and Filter. Clean and replace Stainless Steel Filter and Juicing Cone before continuing to juice. Do not allow the Stainless Steel Filter to overfill as this may prevent correct operation or damage the unit. Step 4. Place a citrus fruit half, cut side down, onto the Juice Cone and push down lightly onto the spikes Step 5. Grasp the Soft Grip Handle and slowly lower the Juicing Press Arm and press down firmly until the Fruit Dome is in contact with the fruit skin. The motor will automatically start and the Juicing Cone will begin to rotate. The juice will be extracted from the fruit and flow through the Juice Spout into the glass, The pulp and seeds will collect in the Stainless Steel Filter. Step 6. The 800 Class Citrus Press juices very quickly so each fruit half will be juiced in a few seconds. To automatically stop the motor, lift the Juicing Press Arm up and backwards to its extended position. Step 7. Remove the used fruit from the Juicing Cone. [. . . ] Do not use harsh abrasives. Cleaning 16 CARE AND CLEANING 17 TROUBLE SHOOTING GUIDE TIPS ON JUICING POSSIBLE PROBLEM Will not work EASY SOLUTION Switch not `On' Arm not lowered Cone or Dome not assembled properly Make sure pulp filter is aligned correctly THE INSIDE INFORMATION ON JUICE Although juice drinks are usually developed with flavour, texture and aroma at the forefront, the health benefits certainly add to the pleasurable taste experience. 95% of the nutrient content of fruit and vegetables is found in the juice. Liquids are an important part of a well balanced diet. Fresh juice is an easy source of vitamins and minerals. [. . . ]