User manual BREVILLE BES200XL

[. . . ] 2006 Due to continual improvements in design or otherwise, the product you purchase may differ slightly from the one illustrated in this booklet. Page Breville recommends safety first Know your Breville Espresso/Cappuccino Machine Operating your Breville Espresso/Cappuccino Machine Coffee making tips Care and cleaning Troubleshooting chart Coffees to try French 4 6 7 11 12 14 15 F1 We at Breville are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer foremost in mind. In addition we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions: Only use cold water in the water tank. [. . . ] If steam starts coming from the Steam Wand before it is immersed in the milk, pause the steam by turning the Selector Control back to the `STAND BY' position. This will avoid the steam pressure blowing milk out of the jug. A pumping noise will sound for a short time. For optimal coffee temperature, pre-warm the espresso cups by placing them on the cup warming plate. Gently move the frothing jug in a circular motion around the froth enhancer. When the milk has begun to increase in volume, immerse the froth enhancer deeper into the milk to further heat the milk. Place your hand on the bottom of the stainless frothing jug. When the jug becomes too hot to touch, turn the selector control to the `STAND BY' position to stop the steaming function before removing the jug. Pour the steamed milk to each cup of freshly brewed espresso coffee and spoon on the frothed milk in the following ratio's: Cappuccino - 1/3 espresso, 1/3 steamed milk, 1/3 frothed milk. Latte - 1/3 espresso topped with steamed milk and about 10cm of frothed milk, (traditionally served in a glass). Always ensure that the Froth Enhancer has been firmly pushed onto the steam wand. For best results use fresh cold milk (lite milk will froth easier). Always clean the steam wand and froth enhancer after every use (refer to care and cleaning). Plug the power cord into a 110-120V electrical outlet and switch on. The orange `heating' light turns off when the machine has reached the correct temperature. After a few seconds*, aromatic coffee will begin to brew into the cups. A pumping noise will be heard in this operation. As soon as the orange `heating' light has switched off, quickly insert the steam wand into jug the of milk so that the froth enhancer is immersed 10mm into the milk. For brewing more coffee immediately after using the steam function, the BarVista Espresso/Cappuccino Machine features an auto-purge system. This ensures that the ground coffee will not be burnt by the initial water flow from the Thermoblock that could be too hot. Instead this water is automatically released internally into the Drip Tray ensuring that the internal thermostat is at optimal temperature for extracting coffee. Your coffee will always be extracted at this optimal temperature ensuring only the best flavoured coffee is achieved. [. . . ] It is served in a small cup or glass to a level of approximately 30ml. Coffee runs out too quickly Coffee runs out around the edge of the filter holder Coffee grind is too coarse · Not enough coffee in the filter · Filter holder is not inserted in the brew head properly There are coffee grounds around the filter rim Too much coffee in the filter Coffee has been tamped too tightly A single dose of espresso in a cup topped with steamed milk, 1/3 coffee and 1/3 milk. Traditionally the morning coffee of Italy and France, taken with pain au chocolate or sweet biscotti. This blend of 1/3 espresso to 2/3 milk is made with a single shot of espresso. [. . . ]