User manual BREVILLE BKE360

[. . . ] · Keep the kettle clear of walls, curtains and other heat or steam sensitive materials. · Do not operate the kettle on a sink drain board. · Always ensure the kettle is properly assembled before connecting to a power outlet and operating. Follow the instructions provided in this book. [. . . ] THIS MAY RESUlT IN BOIlING WATER SPlASHING FROM THE KETTlE. POUR All THE HOT WATER FROM THE KETTlE BEFORE OPENING THE lID TO REFIll. WARNING: THIS APPlIANCE IS DESIGNED FOR BOIlING OF DRINKING QUAlITY WATER ONlY. NEvER USE IT TO HEAT OR BOIl ANY OTHER lIQUIDS OR FOODSTUFFS. THE lID SHOUlD AlWAYS BE lOCKED FIRMlY IN PlACE IN THE ClOSED POSITION BEFORE USE. 6 Operating your Breville Stainless Steel Kettle Before first use Remove and safely discard any packaging material or promotional labels before using your kettle for the first time. It is recommended before the first use to fill the kettle to the maximum level with cold tap water, bring to the boil then discard the water. Your kettle will only operate when positioned on the power base with the ON/OFF switch in the ON position. The kettle will automatically switch to the OFF position when the water has boiled. The kettle will automatically switch to the OFF position when the water has boiled. Lift the kettle from the power base and pour the water. Take care to hold the kettle level, especially when filled to the maximum (MAX) level. To re-boil it may be necessary to wait for a few seconds to allow the control to reset. If further heating of the kettle is not required, switch off at the power outlet, unplug the power cord and empty the water from the kettle. Replace the kettle onto the power base and close the lid. This kettle must be used with the power base supplied. Use caution when pouring water from your kettle, as boiling water and steam will scald. Do not pour the water too quickly. Operation of your kettle 1. To fill the kettle with water, remove the kettle from the power base and open the lid by lifting up the safety locking hinged lid. Fill with the desired amount of water. Always ensure the filter is properly placed back in position before operating the kettle. Safety boil dry protection 2. Ensure the lid is closed and locked securely into place. Position the kettle firmly onto the power base. Insert the power plug into a 230/240V power outlet and switch on. Press the ON/OFF switch down to the ON position. [. . . ] Repeat and the kettle will be ready for use. The concealed element in the base of the kettle is made from high quality stainless steel. Any brown stains appearing are the result of mineral deposits and are not rust. WARNING: NEvER IMMERSE THE KETTlE BASE, SWITCH AREA, POWER BASE, POWER CORD OR POWER PlUG IN WATER, OR AllOW MOISTURE TO COME INTO CONTACT WITH THESE PARTS. 8 Care, cleaning and storage continued To clean the exterior The outside of the kettle should be wiped with a damp cloth and polished with a soft, dry cloth. Storage Ensure the kettle is switched off, cleaned and dried before storing. Ensure that the lid is closed and locked securely into place. Wrap the power cord around the cord storage under the power base. [. . . ]