User manual BREVILLE VCF126X01 BARISTA MAX

[. . . ] Read carefully and save all the instructions provided with an appliance. Do not remove the Group Handle during the espresso pour or water flow as the unit is under pressure. Removing the Group Handle during either of these operations can lead to a scalding or injury. The Steam & Hot Water Wand becomes very hot during texturing milk and water flow. [. . . ] Note: The Cleaning Cycle can be exited at any point by pressing the ON/OFF BUTTON. - The ON/OFF & CLEAN LIGHTS will flash during the cleaning cycle. - Water will purge into the Drip Tray and small amounts of water will pour from the Group Handle spouts. - The machine will return to the READY state. - Remove the Group Handle from the Group Head. Note: If the tablet has not been dissolved, insert the Group Handle back into the Group Head, empty the Drip Tray & replace. Repeat the `Start the Cleaning Cycle' section. - Purge the Group Head by pressing the ONE CUP BUTTON and water should flow. - Allow water to run through until it stops. - Wash the Drip Tray, Group Handle & Cleaning Disc in warm water with a mild detergent, rinse & dry. group Head Silicone Seal A Silicone Seal is located in the Group Head and creates a seal against the Filter basket when making an espresso. Important: When not being used, we recommend not to leave the Group Handle inserted into the Group Head, as this will reduce the life of the Silicone Seal. Over time this Seal loses its elasticity and may require replacement. The seal may need replacing when watery espresso leaks from around the Group Handle during extraction, or if the Group Handle is loose when fully turned to the centre position. Note: Contact Breville should you think that the Group Head Seal needs replacing. Do not attempt to change the Silicone Seal without first consulting Breville. Every time - After texturing milk purge the Steam Wand by turning the DIAL to HOT WATER for just 1-2 seconds. - Wipe the Steam Wand with a damp cloth. 2-3 Months - Soak the Steam Wand overnight in the Milk Jug with warm water & one Cleaning Tablet. eMCSTAPLACERBAHELNSINESINTEOSG - In the morning remove the Jug and rinse ensuring that all traces of the solution have been removed. - Wipe Steam Wand with a damp cloth ensuring that all traces of the cleaning tablet have been removed. - Run Hot Water through the Steam Wand for 40 seconds. [. . . ] Ensure the dot on the Top Cover aligns with the dot on the Grinder Collar. Coffee beans or grinds are caught in the Top Burr or Grinder Collar. Grinder Collar not aligned to the Top Cover. Coffee beans or grinds are caught around & under the Top Burr The Top Burr is not seated correctly. [. . . ]