User manual BRIGGS & STRATTON 110000 AND 120000

[. . . ] For replacement parts or technical assistance, record below the engine model, type, and code numbers along with the date of purchase. These numbers are located on your engine (see the Features and Controls page). The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. MM/DD/YYYY Type: Code: Briggs & Stratton does not approve or authorize the use of these engines on 3-wheel All Terrain Vehicles (ATVs), motor bikes, fun/recreational go-karts, aircraft products, or vehicles intended for use in competitive events. [. . . ] Some models are equipped with an optional oil filter. Before you install the new oil filter, lightly lubricate the oil filter gasket with fresh, clean oil. Install the oil filter by hand until the gasket contacts the oil filter adapter, then tighten the oil filter 1/2 to 3/4 turns. As the engine warms up, check for oil leaks. Stop the engine and check the oil level. see the Specifications section for oil capacity. Remove the dipstick (G) and wipe with a clean cloth (Figure 2). Pour the oil slowly into the engine oil fill (H). After adding oil, wait one minute and then check the oil level. Gasoline and its vapors are extremely flammable and explosive. Never start or run the engine with the air cleaner assembly (if equipped) or the air filter (if equipped) removed. NOTICE: Do not use pressurized air or solvents to clean the filter. If the filter is excessively dirty, replace with a new filter. After the oil has drained, install and tighten the oil drain plug. If you drain the oil from the top oil fill tube (C), keep the spark plug end of the engine (D) up (Figure 10). Install air filter cover and secure with fastener. Engine Oil While the engine is still warm, change the engine oil. Gasoline and its vapors are extremely flammable and explosive. fire or explosion can cause severe burns or death. Keep gasoline away from sparks, open flames, pilot lights, heat, and other ignition sources. Before replacing the fuel filter, drain the fuel tank or close the fuel shut-off valve. replacement parts must be the same and installed in the same position as the original parts. [. . . ] The use of any non exempted add on or modified parts by the owner will be grounds for disallowing a warranty claim. The manufacturer will not be liable to warrant failures of warranted parts caused by the use of a non exempted add on or modified part. Engines that are certified to meet the California Air Resources Board (CARB) Emissions Standard must display information regarding the Emissions Durability Period and the Air Index. Briggs & Stratton makes this information available to the consumer on our emissions labels. [. . . ]