User manual BRIGGS & STRATTON 12A600

[. . . ] GB BG CR CZ EE H LT LV PL RO RU SL Operating & Maintenance Instructions Upute za korictenje i odravanje Nvod k obsluze a drb Kasutus- ja hooldusjuhend Kezelsi s karbantartsi tmutat Naudojimo ir aptarnavimo instrukcija Lietoanas un apkopes instrukcija Instrukcja Obsugi i Konserwacji Instruciuni de utilizare i de ntreinere Navodila za uporabo & vzdrevanje Model 120000 Intek 825/850/875 Series Intek Edge 825/850 Series Intek Pro 825 Series BRIGGSandSTRATTON. com E Copyright Briggs & Stratton Corporation Milwaukee, Wisconsin 53201 U. S. A. Form No. 1 7 8 9 1 10 6 12 11 5 4 3 2 Fig. 2 ** * 0. 15 LITERS F C -20 -30 -20 0 -10 20 32 0 40 10 60 20 80 30 100 40 Fig. 6 Note: (This note applies only to engines used in the U. S. A. ) Maintenance, replacement or repair of the emission control devices and systems may be performed by any nonroad engine repair establishment or individual. [. . . ] Install cartridge/pre-cleaner assembly in base . Place cover on air cleaner and tighten screws securely to base. Carefully remove pre-cleaner (if equipped) and cartridge assembly from cover 2. After servicing pre-cleaner and cartridge, place precleaner, if equipped, over cartridge pleats with arrows in direction shown (pre-cleaner lip will be at bottom of pleats). Install pre-cleaner and cartridge assembly in cover. Insert tabs on cover into slots in bottom of base. Tilt cover up and tighten screw securely to base. Fig. 4 BEFORE STARTING Check oil level. Move throttle control to FAST position. Push primer bulb 3 times, if equipped. 5 STARTING ENGINE Pull back safety brake control handle then, Pull rope handle slowly until resistance is felt. Then pull cord rapidly to overcome compression, prevent kickback and start engine. CAUTION: To prolong starter life, use short starting cycles (5 seconds maximum, then wait one minute). Follow equipment manufacturer's recommendations for charging battery. If choke equipped: Slowly adjust toward RUN position. Wait until engine runs smoothly before each choke adjustment. Fig. 6 STOPPING Do not stop engine by moving choke control to CHOKE. Backfire, fire or engine damage could occur. 3 WARNING FUEL SYSTEM WARNING Replacement parts for fuel system (tank, hoses, valves, etc. ) must be the same quality as original parts, otherwise fire can occur. STORAGE Engines stored over 30 days need special attention. To prevent gum from forming in fuel system or on essential carburetor parts: a) if fuel tank contains oxygenated or reformulated gasoline (gasoline blended with an alcohol or an ether), run engine until it stops from lack of fuel, or b) if fuel tank contains gasoline, either run engine until it stops from lack of fuel, or add a gasoline stabilizer to the gas in the tank. SERVICE We recommend that you see an authorized Briggs & Stratton Service Dealer for all maintenance and service of the outboard and outboard parts. Use only genuine Briggs & Stratton parts. Each Authorized Briggs & Stratton Service Dealer carries a stock of Genuine Briggs & Stratton Parts and is equipped with special service tools. [. . . ] To avoid misunderstanding which might occur between the customer and the Dealer, listed below are some of the causes of engine failure that the warranty does not cover. Normal wear: Engines, like all mechanical devices, need periodic parts service and replacement to perform well. Warranty will not cover repair when normal use has exhausted the life of a part or an engine. Improper maintenance: The life of an engine depends upon the conditions under which it operates, and the care it receives. [. . . ]