User manual BRIGGS & STRATTON 195499 SCHEMATICS

[. . . ] This high quality residential system features an axial cam pump with stainless steel pistons, an automatic cool down system, chemical injection system and adjustable spray nozzle. includes safety goggles , heavy-duty 25' hose , and more. Every effort has been made to ensure that information in this manual is accurate and current. However, we reserve the right to change, alter or otherwise improve the product and this document at any time without prior notice. [. . . ] Check for properly tightened hose connections (high pressure and water supply) and there are no kinks, cuts, or damage to high pressure hose. provide a proper water supply at an adequate flow. Be sure to read "Safety Rules" and "How To Use Pressure Washer" before using pressure washer. If you have any problems operating your pressure washer, please contact the local Briggs & Stratton service center. To start your pressure washer for the first time, follow these instructions step-by-step. This starting information also applies if you have let the pressure washer sit idle for at least a day. Place pressure washer near an outside water source capable of supplying water at a flow rate greater than 3. 0 gallons per minute and no less than 20 PSI at pressure washer end of garden hose. Check that high pressure hose is tightly connected to spray gun and to pump. see "Preparing Pressure Washer for Use" for illustrations. Connect garden hose to water inlet on pressure washer pump. If engine starts and fails to continue to run or if increased resistance is felt during starting pull attempts, squeeze trigger on spray gun. The high pressure stream of water that this equipment produces can pierce skin and its underlying tissues, leading to serious injury and possible amputation. Spray gun retains high pressure when pressure washer is shut down, which can cause injury. Keep high pressure hose connected to pump and spray gun while system is pressurized. Squeeze trigger on spray gun to relieve trapped pressure, every time you stop engine. Engage trigger lock on spray gun when not in use. You now should know how to START your pressure washer and how to STOP it. The information in this section will tell you how to adjust the spray pattern and to apply detergent or other cleaning chemicals. NOTE: Always keep the throttle lever in the "Fast" position when operating the pressure washer. Allow equipment to cool before touching. The pressure washer must be at least 5 feet from structures having combustible walls and/or other combustible materials. [. . . ] Some states or countries do not allow limitations on how long an implied warranty lasts, and some states or countries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state or country to country. 1 year 90 days 1 year 90 days 2 years 1 year 3 years or 1500 hours none The engine and starting batteries are warranted solely by the manufacturers of those products. 2 years for all consumer products in the European Union. [. . . ]