User manual BRIGGS & STRATTON 2400 PSI REV 04-24-2007

[. . . ] A warning tag (Figure 1) is provided on your unit to inform you of potential safety hazards. If the tag becomes damaged or illegible, replace it by contacting your local Briggs & Stratton dealer to obtain a new one. Read this manual carefully and become familiar with your pressure washer. Know its applications, its limitations and any hazards involved. [. . . ] Check for properly tightened hose connections (high pressure and water supply) and there are no kinks, cuts, or damage to high pressure hose. provide a proper water supply at an adequate flow. Be sure to read "Safety Rules" and "How To Use Pressure Washer" before using pressure washer. If you have any problems operating your pressure washer, please contact the local Briggs & Stratton service center. To start your pressure washer for the first time, follow these instructions step-by-step. This starting information also applies if you have let the pressure washer sit idle for at least a day. Place pressure washer near an outside water source capable of supplying water at a flow rate greater than 3. 0 gallons per minute and no less than 20 PSI at pressure washer end of garden hose. Check that high pressure hose is tightly connected to spray gun and to pump. see "Preparing Pressure Washer for Use" for illustrations. Connect garden hose to water inlet on pressure washer pump. Turn ON water, point gun in a safe direction and squeeze trigger to purge pump system of air and impurities. DO NOT place pressure washer where exhaust gas could accumulate and enter inside or be drawn into a potentially occupied building. When starting engine, pull cord slowly until resistance is felt and then pull rapidly to avoid kickback. After each starting attempt, where engine fails to run, always point gun in safe direction and squeeze spray gun trigger to release high pressure. Firmly grasp spray gun with both hands when using high pressure spray to avoid injury when gun kicks back. The high pressure stream of water that this equipment produces can pierce skin and its underlying tissues, leading to serious injury and possible amputation. Spray gun traps high water pressure, even when engine is stopped and water is disconnected, which can cause injury. Keep high pressure hose connected to pump and spray gun while system is pressurized. ALWAYS point gun in safe direction and squeeze spray gun trigger, to release high pressure, every time you stop engine. Engage safety latch on spray gun when not in use. NOTE: Always keep the throttle lever in the "Fast" position when operating the pressure washer. [. . . ] Briggs & Stratton Power Products Group, LLC will repair or replace, free of charge, any part(s) of the pressure washer that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for the time periods and subject to the conditions stated below. For warranty service, find the nearest Authorized Service Dealer in our dealer locator map at BRIGGSandSTRATTON. [. . . ]