User manual BRIGGS & STRATTON 350400

[. . . ] For replacement parts or technical assistance, record below the engine model, type, and code numbers along with the date of purchase. These numbers are located on your engine (see the Features and Controls page). The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. MM/DD/YYYY Type: Code: Briggs & Stratton does not approve or authorize the use of these engines on 3-wheel All Terrain Vehicles (ATVs), motor bikes, fun/recreational go-karts, aircraft products, or vehicles intended for use in competitive events. [. . . ] We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts. CAUTION: All the components used to build this engine must remain in place for proper operation. Maintenance, replacement, or repair of the emissions control devices and systems may be performed by any non-road engine repair establishment or individual. However, to obtain "no charge" emissions control service, the work must be performed by a factory authorized dealer. If replacement parts are required, make sure to use only original equipment replacement parts. WARNING: Replacement parts must be the same and installed in the same position as the original parts or fire could result. CAUTION: Used oil is a hazardous waste product and must be disposed of properly. Check with your local authorities, service center, or dealer for safe disposal/recycling facilities. Disconnect the spark plug wire and keep it away from the spark plug. Do not tamper with governor spring, links or other parts to increase engine speed. replacement parts must be the same and installed in the same position as the original parts. Do not strike the flywheel with a hammer or hard object because the flywheel may later shatter during operation. With engine off but still warm, disconnect the spark plug wire (A) and keep it away from the spark plug (Figure 8). After the oil has drained, install and tighten the oil drain plug. Some models are equipped with oil filter. Before you install the new oil filter, lightly lubricate the oil filter gasket with fresh, clean oil. Install the oil filter by hand until the gasket contacts the oil filter adapter, then tighten the oil filter 1/2 to 3/4 turns. As the engine warms up, check for oil leaks. Stop the engine and check the oil level. Do not check for spark with spark plug removed. Change oil Check engine oil level Clean area around muffler and controls Every 8 Hours or Daily Clean the oil fill area of any debris. Remove the dipstick (D) and wipe with a clean cloth (Figure 11). [. . . ] Any Warranted Part which is scheduled for replacement as required maintenance shall be warranted as to defects only for the period of time up to the first scheduled replacement for that part. Any replacement part that is equivalent in performance and durability may be used in the performance of any maintenance or repairs. Consequential Coverage Coverage hereunder shall extend to the failure of any engine components caused by the failure of any Warranted Part still under warranty. Connectors and assemblies Length of Coverage B&S warrants to the initial owner and each subsequent purchaser that the Warranted Parts shall be free from defects in materials and workmanship which caused the Engines that are certified to meet the California Air Resources Board (CARB) Emissions Standard must display information regarding the Emissions Durability Period and the Air Index. [. . . ]