User manual BRIGGS & STRATTON 474100

[. . . ] 470000, 610000 GB D DK E F GR I N NL P S SF Operating & Maintenance Instructions Betriebsanleitung & Wartungsvorschriften Drifts og vedligeholdelsesvejledning Instrucciones de Mantenimiento & Operación Instructions d'utilisation et de maintenance Ïäçãßåò Ëåéôïõñãßáò & ÓõíôÞñçóçò Istruzioni per l'uso e la manutenzione Anvisninger for bruk og vedlikehold Gebruiksaanwijzing Instruções de operação e de manutenção Instruktionsbok Käyttö & Huolto ohjeet Briggs & Stratton Corporation Milwaukee, Wisconsin 53201 www. briggsandstratton. com © Copyright 2005 by Briggs & Stratton Corporation FORM NO. 1 12 7 4 5 8 9 10 11 6 3 2 1 2 20 16 19 13 18 17 15 14 13 Fig. 4 Ê Í Ì Ë Ì Note: (This note applies only to engines used in the U. S. A. ) Maintenance, replacement or repair of the emission control devices and systems may be performed by any nonroad engine repair establishment or individual. However, to obtain no charge repairs under the terms and provisions of the Briggs & Stratton warranty statement, any service or emission control part repair or replacement must be performed by a factory authorized dealer. [. . . ] Other parts may not perform as well, may damage the engine, and may result in injury. In addition, use of other parts may void your warranty. 1. Remove cartridge Ë from air cleaner body, and inspect. Replace if very dirty or any damage occurs to cartridge. Transfer safety cartridge Ì to new air cleaner cartridge. Install cover and lock clamps with rubber valve down. CAUTION: Used oil is a hazardous waste product. Check with your local authorities, service center, or dealer for safe dis posal/recycling facilities. 3 CHANGING COOLANT WARNING Never remove radiator cap or radiator reservoir cap while the engine is hot or running. Severe thermal burns or inju ry can occur by escaping steam or hot engine coolant. 2. Fit torque wrench in the square torque hole Í located on the bracket. Apply 115 in lbs (13 Nm) of torque in the direction of the arrow to tension the belt. Tighten bolt Ë and bolt Ì 135 in lbs (15 Nm). 2. (30 ml) of engine oil into each cylinder. Replace spark plugs and crank slowly to distribute oil. Clean engine of surface debris, chaff or grass. CLEANING DEBRIS Fig. 10 Daily or before every use, clean accumulated debris from engine Ê. Keep area around and behind muffler free of any combustible debris. Use the handle Ë on the radiator screen to lift off for clean ing. Clean screen thoroughly and clean radiator fins. WARNING · Stop engine and allow to cool before removing · To remove reservoir cap after engine is cool, place a · To remove radiator cap after engine is cool, place a thick cloth over cap and rotate it slowly counter clock wise to the first stop. Pressurized steam may emit from the cap, stand back to avoid injury. Once all pressure is released, rotate cap counter clockwise while pushing down on cap to remove. thick cloth over cap and remove it slowly. [. . . ] This warranty covers engine related defective material and/ or workmanship only, and not replacement or refund of the equipment to which the engine may be mounted. Nor does the warranty extend to repairs required because of: 1. PROBLEMS CAUSED BY PARTS THAT ARE NOT ORIGINAL BRIGGS & STRATTON PARTS. Equipment controls or installations that prevent starting, cause unsatisfactory engine performance, or shorten en gine life. [. . . ]