User manual BRIGGS & STRATTON 490000

[. . . ] This manual contains safety information to make you aware of the hazards and risks associated with engines and how to avoid them. It also contains instructions for the proper use and care of the engine. Because Briggs & Stratton Corporation does not necessarily know what equipment this engine will power, it is important that you read and understand these instructions and the instructions for the equipment. Save these original instructions for future reference. [. . . ] Turn the key to the off position before disconnecting, removing and/or installing the battery. Never disconnect the battery cables while the engine is running. When connecting the battery cables, first connect the positive (+) cable and then connect the negative (--) cable to the battery. When charging the battery, turn the ignition switch to the off position and disconnect the negative (--) battery cable from the battery. Disconnect the spark plug wire and keep it away from the spark plug. With engine off but still warm, disconnect the spark plug wire (A) and keep it away from the spark plug (Figure 6). Note: Any of the oil drain plugs shown below may be installed in the engine. Remove accumulated debris from muffler area and cylinder area. If damage is found, install replacement parts before operating. After the oil has drained, install and tighten the oil drain plug. Disconnect the oil drain hose (G, Figure 6) from the side of the engine. Carefully lower the quick oil drain (I) into an approved container (J). After the oil has drained, install the oil drain cap. Before you install the new oil filter, lightly lubricate the oil filter gasket with fresh, clean oil. Install the oil filter by hand until the gasket contacts the oil filter adapter, then tighten the oil filter 1/2 to 3/4 turns. NOTICE: Do not use pressurized air or solvents to clean the filter. Some models are also equipped with a pre-cleaner that can be washed and reused. If the filter is excessively dirty, replace with a new filter. Assemble the dry pre-cleaner and the filter into the engine base (D). If the filter is excessively dirty, replace with a new filter. Install the filter into the engine base (D) and push down until the filter snaps in place. Fuel and its vapors are extremely flammable and explosive. [. . . ] the warranty on emissions-related parts is as follows: 1. Warranted Emissions Parts Coverage under this warranty extends only to the parts listed below (the emissions · Any warranted part that is not scheduled for replacement as required control systems parts) to the extent these parts were present on the engine maintenance in the owner's manual supplied, is warranted for the warranty purchased. If any such part fails during the period of warranty coverage, the part will be repaired or replaced by B&S at no charge to the a. Any warranted part that is scheduled only for regular inspection in the owner's · Fuel line, fuel line fittings, clamps part repaired or replaced under warranty will be warranted for the remaining · Any such part repaired or replaced under warranty will be warranted for the remainder of the period prior to the first scheduled c. [. . . ]