User manual BRIGGS & STRATTON 7000 WATT GENERATOR SYSTEM

[. . . ] No part of this material may be reproduced or transmitted in any form by any means without the express written permission of Briggs & Stratton Power Products Group, LLC. The safety alert symbol ( ) is used with a signal word (DANGER, CAUTION, WARNING), a pictorial and/or a safety message to alert you to hazards. DANGER indicates a hazard which, if not avoided, will result in death or serious injury. WARNING indicates a hazard which, if not avoided, could result in death or serious injury. [. . . ] The entire flexible gaseous pipe must be visible for periodic inspection and must not be concealed within, contact, or run through any wall, floor, or partition. The Home Generator System unit has been factory set to run on natural gas. If you need to change from natural gas to LP gas, the unit will need to be reconfigured, as described on page 19. A manual fuel shut-off valve located outside the building, just before the generator unit. Where the formation of hydrates or ice is known to occur, piping should be protected against freezing. The termination of hard piping should include a sediment trap where condensate is not likely to freeze. The manometer port permits temporary installation of a manometer (Figure 5), to ensure that the engine receives the correct fuel pressure to operate efficiently throughout its operating range. When the initial test runs are completed, the manometer is removed and the port is plugged. See Figure 7 for estimated fuel supply requirements at half and full load for both natural gas and LP vapor. * = Natural Gas is in cubic feet per hour ** = LP Vapor is in cubic feet per hour Figures 8 and 9 provide the maximum capacity of pipe in cubic feet of gas per hour for gas pressures of 0. If an unusual number of fittings, bends, or other restrictions are used, please refer to federal and local codes. Figure 8 -- NATURAL GAS (NG) Pipe Size - Gas Flow Chart, in cubic feet per hour Figure 9 -- LIQUID PROPANE (LP) GAS Pipe Size - Gas Flow Chart, in cubic feet per hour ** Gross Heat Value does not consider heat lost in the form of water during combustion. *** Density is given in "Cubic Feet of Gas per Gallon of Liquid". Weight is given in "Pounds per Gallon of Liquid". Given the gas withdrawal rate and the lowest average winter temperature, an installer can specify the required LP storage tank size: The LED will stay lit indicating the generator is in ready mode and will turn on and off in a series of blinks if certain faults are detected in the Home Standby Generator. This engine is shipped from the factory filled with the recommended oil. Before starting the engine, check oil level and ensure that engine is serviced as described in the engine operator's manual. The stator assembly consists of a pair of stationary windings with two leads brought out of each winding. the junction of leads 22 and 33 forms the neutral lead. A complete schematic and wiring diagram can be found on pages 26-27. NOTE: Neutral is not bonded to ground at generator. Any attempt to crank or start the engine before it has been properly serviced with the recommended oil will result in equipment failure. [. . . ] For warranty service, find the nearest Authorized Service Dealer in our dealer locator map at BRIGGSandSTRATTON. Some states or countries do not allow limitations on how long an implied warranty lasts, and some states or countries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state or country to country. The warranty period begins on the date of purchase by the first retail consumer or commercial end user, and continues for the period of time stated in the table above. [. . . ]