User manual BRIGGS & STRATTON ZM ILLUSTRATED PARTS LISTS

[. . . ] CAUTION indicates a hazard which, if not avoided, might result in minor or moderate injury. nOTICE , indicates a situation that could result in equipment damage. Follow safety messages to avoid or reduce the risk of injury or death. The manufacturer cannot possibly anticipate every possible circumstance that might involve a hazard. [. . . ] In no way should this information be interpreted to conflict with applicable fuel gas codes. Consult with your local fuel supplier or Fire Marshall if questions or problems arise. TO THE INSTALLER: Consult with the Home Generator System owner(s) and convey any technical considerations that might affect their installation plans before applying these general guidelines. The following general rules apply to gaseous fuel system piping: · The piping should be of a material that conforms to federal and local codes, rigidly mounted and protected against vibration. Piping should be protected from physical damage where it passes through flower beds, shrub beds, and other cultivated areas where damage could occur. 3 (supplied) between the Home Generator System Fuel Inlet port and rigid piping to prevent thermal expansion or contraction from causing excessive stress on the piping material. Before placing the Home Generator System into service, the fuel system lines must be properly purged and leak tested. Consider the following factors when planning to install the fuel supply system: The Home Generator System engine is fitted with a fuel mixer system that meets the specifications of the California Air Resources Board for "tamper-proof" dual fuel systems. The unit will run on natural gas or liquefied propane vapor. A minimum of one accessible, approved manual shutoff valve shall be installed in the fuel supply line within 6 ft (1. A union or flanged connection shall be provided downstream from this valve to permit removal of controls. NOTE: Neutral is not bonded to ground at generator. Any attempt to crank or start the engine before it has been properly serviced with the recommended oil will result in equipment failure. Refer to engine manual for oil fill information. Damage to equipment resulting from failure to follow this instruction will void warranty. These two leads must be routed in conduit. Control lead functions are briefly described as follows: · Leads deliver utility power to the generator's circuit board, optional battery warmer and oil heater and charge the battery. Using installer-supplied minimum 300V, 14 AWG copper wire, connect control circuit terminals in the disconnect box to the Transfer Switch. Oil Considerations Your Home Standby Generator is equipped with an engine that has been pre-run at the factory and does not require the traditional "break-in" procedure. The generator is filled with synthetic oil (API SJ/CF 5W30W). this allows for generator operation in the widest range of temperature and climate conditions. NOTE: The use of synthetic oil DOES NOT alter the required oil change intervals described in the engine operator's manual. [. . . ] * - Items without part numbers are common fasteners and are available at local hardware stores. Briggs & Stratton Power Products Group, LLC will repair or replace, free of charge, any part(s) of the equipment that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for the time periods and subject to the conditions stated below. [. . . ]