User manual BRIGGS & STRATTON ZZL ILLUSTRATED PARTS LISTS

[. . . ] This high quality residential system features an axial cam pump with stainless steel pistons, an automatic cool down system, chemical injection system and adjustable spray nozzle. includes safety goggles , heavy-duty 25' hose , and more. Every effort has been made to ensure that information in this manual is accurate and current. However, we reserve the right to change, alter or otherwise improve the product and this document at any time without prior notice. [. . . ] Run water through garden hose for 30 seconds to clean out any debris. Turn ON water, point gun in a safe direction and squeeze trigger to purge pump system of air and impurities. High pressure spray can cause paint chips or other particles to become airborne. Always wear safety goggles when using this equipment or in vicinity of where equipment is in use. Before starting the pressure washer, be sure you are wearing adequate safety goggles. Use ONLY cold water (less than 100°F). Attach female quick connect to garden hose. Connect garden hose (not to exceed 50 feet in length) to water inlet (Figure 8). Pull back on collar of quick connect, slide fitting onto pump and let go of collar. Pull on hose to be sure of a tight connection. Check that oil has been added to proper level in engine crankcase. Water will flow out of spray gun in thin stream. continue to hold trigger until steady stream of water occurs and no air remains in system. This will make it easier to pull start the engine. Engage safety latch to spray gun trigger (Figure 11). Figure 11 -- Spray Gun with Safety Latch Engaged When starting engine, position yourself as recommended in Figure 12 and start engine according to instructions given in engine operator's manual. Allow equipment to cool before touching. Turn engine off according to instructions given in the engine owner's manual. ALWAYS point gun in a safe direction and squeeze spray gun trigger to release retained high water pressure. IMPORTANT: Spray gun traps high water pressure, even when engine is stopped and water is disconnected. Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than you can let go. Broken bones, fractures, bruises or sprains could result. [. . . ] Engine runs good at no-load but "bogs" when load is added. Push nozzle forward for low pressure mode. move throttle control to FAST position. If engine still "bogs down", contact engine manufacturer. [. . . ]