User manual BRITAX 3 IN 1 PORTABLE COT

[. . . ] Do not use parts or accessories except those tested and approved by Britax. Always check that the folding parts are fully locked before using the cot. Do not place more than one child in the cot at the same time. Do not use this cot with a child who can climb out, weighs more than 15kg, or is taller than 90cms. [. . . ] To help prevent this occurring, do not fold or store the product if it is damp or wet. Always store the product in a well ventilated area. To maintain the safety of your nursery product, seek prompt repairs for bent, torn, worn or broken parts. Use only those parts and accessories tested and approved by Britax. D WARNING: IF THE SIDES DO NOT LATCH FIRMLY OR THERE ARE HOLES IN THE MESH SIDES, DISCONTINUE USE IMMEDIATELY AND SEEK REPAIR. TESTED AND APPROVED ACCESSORIES Mattress by Steelcraft Bassinet by Steelcraft E/F Change Table by Steelcraft - series S600 - series S600 - series S600 THESE STEPS WILL ENSURE THAT THE COT IS CORRECTLY OPENED AND READY FOR USE. A B Unzip the carry bag and remove the cot. Stand the cot on its feet and undo the hook & loop straps that hold the mattress around the frame. C Remove the mattress and set it aside. E Starting with the short rails pull the centre up with both hands quickly until they are locked in place. (CAUTION: TAKE CARE, AS FINGER PINCHING CAN OCCUR IN THE CORNERS WHEN LOCKING THE RAILS IN PLACE. ) F Now do the same with the longer rails. NOTE: ALL THE TOP RAILS SHOULD BE LOCKED IN PLACE. IF THEY ARE NOT, RELEASE THEM AND TRY AGAIN. THE CENTRE OF THE COT BASE MUST BE IN A RAISED POSITION TO ALLOW THE RAILS TO LOCK EASILY. CHECK FOR THE SECURE ENGAGEMENT OF THE RAILS BY PUSHING DOWN ON THEM. G Holding one end of the cot clear of the ground, gently press down on the handle in the middle of the base until the base lays down flat. Then turn the handle clockwise to lock the base in position and fold the handle down so it lies flat in the cot base. G 04 www. britax. com. au www. britax. com. au 09 5. A TO USE THE CHANGE TABLE Lay the change table padded side down. Connect the straight rod (tube with 2 holes at each end) to one of the corner rods. With the corner rod curved upwards, push the straight rod into the sleeve to one side of the change table by gathering the fabric until it protrudes out the opposite end. Connect the remaining corner rod to the protruding end of the straight rod by engaging the locking pins. Insert the keys into the corner mouldings of the cot and turn the keys back towards you in the direction shown to attach the change table to the cot. Rotate the change table into position and attach press studs. To fold away, flip the change table over the side of the cot. H TO OPEN THE COT (con't) Place the mattress into the cot with its padded side facing up. [. . . ] D Ensure that each rail is fully released and then pull up on the cot base handle, while gathering the legs and the frame together until its fully folded. C C B D DISASSEMBLE AND STORE THE BASSINET AND CHANGE TABLE IN THE CARRY BAG. E Take the mattress and wrap it around the folded cot with the padded side facing inwards. D/E/F F Thread the straps through the plastic loops, pull them tight and secure using the hook and loop attachments. [. . . ]