User manual BRITAX B-DUAL

[. . . ] We are pleased that our B-DUAL will accompany your child safely through the first years of his or her life. A child's safety is your responsibility · Read these instructions carefully and make yourself familiar with the pushchair before using it with your child. If your pushchair is used by someone unfamiliar with it (for example grandparents) always show them how the pushchair works. Your child's safety may be affected if you do not follow these instructions. [. . . ] Never lift or push the pushchair by the pushchair seat. Always take your child out of the pushchair seat before you fasten the seat to the pushchair or remove it. A correctly adjusted 5-point harness gives your child the necessary support in the pushchair. For children under 6 months the shoulder straps 17 must run through the lower belt slots 15. For children over 6 months the shoulder straps can run through the upper belt slots 15. If using an alternative harness conforming to BS6684, D ring attachments are found on each side of the pushchair. How to adjust the shoulder strap height correctly: Open the cover on the backrest 20. Push the buckle tongues 47 of the shoulder straps 17 edgewise from the rear through the belt slots 15. Push the buckle tongues 47 back through the appropriate belt slots 15. How to secure your child using the harness: Engage both buckle tongues 16 in the buckle housing 18 with an audible. Always re-adjust the harness when changing the seating position of your child. How to undo the harness: Push on the buckle housing 18 from the front. Use the pushchair for children under 6 months only with the backrest reclined all the way back 20. Pull upwards the backrest adjustment handle 21 with the other hand. How to put the leg support 23 up: Swivel the leg support 23 upwards until it engages in the desired position. How to put the leg support 23 down: Swivel the leg support 23 up slightly. Swivel the leg support 23 downwards until it engages in the desired position. Opening the hood window 30: Open the zipper and fold the hood 11 all the way forwards. How to fasten the apron 48: Pull the apron 48 over the leg support 23 from below. Please refer to the user instructions supplied with your child safety seat. The B-DUAL can be used as a travel system with all Britax/RÖMER infant carriers that are equipped with the "Type A" adapter. The adapter is simply clipped from underneath into the edge of the infant carrier or is already integrated into the infant carrier. [. . . ] You can clean the seat cover and the hood with a sponge and lukewarm soapy water. The plastic parts and the metal parts can be cleaned with a damp cloth. After contact with water the metal parts should be dried off to prevent rust. You can clean the raincover with a damp cloth. [. . . ]