User manual BRITAX BAR GATED BUCKLE

[. . . ] bRITAX RÖMER Kindersicherheit GmbH Britax Excelsior Ltd. *These user instructions apply to the model with and without Travel System Adapter. Differencesin use are described separately: without Travel System Adapter BABY-SAFE plus II with integrated Travel System Adapter BABY-SAFE plus SHR II 4 Securing your baby using the harness . 1 Securing the baby seat in your vehicle . [. . . ] Even outside of the car, please avoid leaving your baby in the baby seat for too long. Push the light grey release button 4 on the With the release button pressed, now swivel 5 Let go of the release button 4 and swivel the This position prevents the handle 5 from being unintentionally swivelled backwards. C : For putting your baby in and when using as a Travel System D: For setting the baby seat down safely outside the car When the headrest is adjusted 16, the inclination of the backrest adapts to the age of the baby. The headrest 16 must be adjusted so that the shoulder straps 3 are at the same level as your baby's shoulders or slightly below. Fold the headrest 16 back onto the seat shell to 4 Securing your baby using the harness Loosen the shoulder straps (see 3. Tighten the straps until they are in contact with The hip belt 25 must lie as low as possible over your baby's hips. 5 Tightening the straps Pull on the adjusting strap 8 until the harness lies There should never be more than one finger's width of space between the shoulder straps and your child's shoulders . Are driving it should always be attached to the hook at the foot end beneath the edge of the shell. For your baby's safety, check that. The straps of the child safety seat are close to the body without constricting the child, · The buckle tongues 2 are engaged in the vehicle seat buckle 1. Please do not leave your child unattended in the child safety seat in the vehicle. Push the bar joint both left and right into the Loops at the into the hook 22 below the baby seat. The baby seat can be used as a Travel System on all pushchair frames which are equipped with the "type A" adapter and which have been approved for use with RÖMER/Britax baby seats. Carrycots, pushchairs and buggies must be only used to transport babies or children. Always secure your baby in the baby seat using the seat belt. Never lift or push the pushchair by the infant carrier. Always apply the brake before fitting the infant carrier onto the pushchair or removing it. Adjust the pushchair seat, unhook the seat cover). Push up the light grey release button 29 on the Travel System Adapters on both sides of the baby seat. Push the light greyreleasebutton 34 on the Lift the baby seat until the fixation prongs 30 are Keep a firm grip on the infant carrier while doing this. You can now remove the baby seat from the The following additional items are available for the baby seat: a rain cover, a cosytoes, a Keep Cool cover and a summer cover. These are available as accessories from your retailer. [. . . ] Simply pull the summer cover through the In an accident at a collision speed above 10 km/ h the child safety seat could suffer damage which is not necessarily obvious. In this case the child safety seat must be replaced. To prevent damage or breakage, ensure that the child safety seat does not become jammed in the car door, seat runners, etc. Should the child seat be damaged (for example after dropping it) it must be inspected by the manufacturer. [. . . ]