User manual BRITAX CHILD BOOSTER SEAT

[. . . ] · DO NOT hang or place items on the stroller handle or frame. They may cause the stroller to become unstable. · Children must always be restrained to prevent standing or falling out of stroller. [. . . ] · Never use stroller on stairs or escalators. · To avoid entrapment or pinching, DO NOT fold or unfold stroller when child is in or near stroller. · Only use accessories and replacement parts approved by Britax Child Safety, Inc. · Read and understand these instructions before using this product. To ensure proper use, store this user guide in a convenient place so it can be consulted often. Failure to follow all warnings and instructions could result in serious injury or death. · Extension adapters are for use with an infant car seat or bassinet in the rear-facing position ONLY. · When using an infant car seat with this product, refer to the product's user guide for maximum weights and other instructions. · Do not exceed the manufacturer's maximum weight limit when using an infant car seat with this product. · In dual infant car seat mode, the child in the lower infant car seat MUST be removed first to avoid tipping. · To avoid tipping always remove child in lower seat first. Never use without primary seat installed and occupied. 3 CHILD BOOSTER SEATTM 2nd Seat Second Seat Features Recline. Lever Canopy Harness. & Buckle Mounting. Lever Support. Bars · Actual product may vary from images. 5 Operating Instructions Attaching the Second Seat NOTE: Storage pouch must be removed before attaching second seat · Line up the support bars on the second seat with the mounting brackets on the inside of the frame · Slide the mounting pins into mounting bracket on the stroller · Press down to until it is locked into place 6 Operating Instructions Removing the Second Seat · Press the left button on the rear frame and then press and hold the right release button while lifting upward on the seat · Slide the mounting pins out of the mounting brackets and lift the second seat away from stroller Second Seat Recline · Lift the recline lever at the top of the seat and raise or lower the seat into one of the four recline positions 7 Operating Instructions Folding Stroller with Second Seat · Recline the second seat to its lowest position and fold back the canopy · Slide the seat folding lever and press the second seat down until it lies flat · Stroller can now be folded as described in the stroller user guide NOTE: You may need to compress the frame to engage the chassis lock 8 CHILD BOOSTER SEAT with Second Seat Second Seat with Infant Car Seat · Attach the extension adapters to the frame by lining up the locking latches with the chassis sockets and pressing down until they lock into place · Attach the fabric guard by connecting the zippers around each side of the frame and securing the elastic bands around the frame hinge bolt IMPORTANT: The fabric guard should always be used with an infant carrier on top to protect the child in the lower seat from possible finger entrapment · Attach top infant car seat by lining up the locking latches with the adapter sockets and pressing down until they lock into place NOTE: Infant car seat can be either forward facing or rear facing 9 Securing Your Child In Second Seat · Unlatch the harness by depressing the button in the center of the buckle while pulling the two tongues away from the buckle assembly · To raise or lower the harness height, unthread the harness clips from the back of the seat NOTE: You may need to loosen the harness to adjust the harness height (See next page) · Rethread the clips at the desired height NOTE: Harness height should be at or above the shoulders of the child 10 Securing Your Child In Second Seat · Buckle the harness by inserting the tongues on the harness straps into the buckle assembly NOTE: Ensure the straps are not twisted as they may become uncomfortable for the child · Tighten or loosen the harness straps by sliding the harness adjusters up or down Buckle tongues separate for added safety. To reconnect buckle tongues, line up the two pieces and slide the upper portion onto the track on the lower piece 11 CHILD BOOSTER SEATTM Bassinet Bassinet Features Canopy Carry. Adjusters Storage. Pouch Seat. Locking. Latch. &. Release. Lever · Actual product may vary from images. 13 Bassinet Assembly · Pull the frame supports outward by the tabs until they lock under all four clips · Place the bassinet bedding into the bassinet and pull the elastic over the ends · Connect the hook and loop fasteners around the carry handle hinge 14 Bassinet Assembly Boot Cover · Lay the cover over the bassinet with the hook and loop fasteners face down · Attach the five hook and loop fasteners 15 Operating Instructions Attaching the Bassinet · Line up the bassinet locking latches with the chassis sockets · Push down until the bassinet locks into place NOTE: Can be used forward facing with the use of the extension adapters (page 9) · Lift gently on the bassinet to ensure that it is secure NOTE: DO NOT pick up stroller with bassinet handle 16 Operating Instructions Removing the Bassinet · Press the locking latch release buttons on both sides of the bassinet and lift upward Folding with Bassinet · The bassinet must be removed before folding stroller Carry Handle/Canopy · Press the hinge buttons on both sides of the carry handle and rotate the handle up or down to the desired position 17 Operating Instructions Bassinet with Second Seat · Attach the bassinet using the extension adapters by lining up the bassinet locking latches with the extension adapter sockets and pressing down until the bassinet locks into place · Attach second seat (Page 6) IMPORTANT: Extension adapters MUST be used when using the bassinet with the second seat TIP: For extra room for the child in the lower seat, the seat can be placed in a reclined position (Page 7) 18 19 CHILD BOOSTER SEATTM Lower Infant Car Seat (LICS) Adapter Lower Infant Car Seat (LICS) Adapter LICS. Adapter. Sockets Mounting. Pins Support. Bars · Actual product may vary from images. 21 Operating Instructions Attaching the LICS Adapter NOTE: Storage pouch must be removed before attaching LICS Adapter · Line up the support bars on the LICS Adapter with the mounting brackets on the inside of the frame · Slide the mounting pins into mounting bracket on the stroller · Press down to engage the accessory frame lock 22 Operating Instructions Attaching Infant Car Seat to LICS Adapter · Line up the locking latches with the LICS sockets and press down until they lock into place Removing the LICS Adapter · Press the left button on the rear frame and then press and hold the right release button while lifting upward on the LICS Adapter · Slide the mounting pins out of the mounting brackets and lift the LICS Adapter away from stroller 23 Operating Instructions Dual Infant Car Seats · Attach the extension adapters to the frame by lining up the locking latches with the chassis locks and pressing down until they lock into place · Attach the fabric guard by connecting the zippers around each side of the frame and securing the elastic bands around the frame hinge bolt IMPORTANT: The fabric guard should always be used with an infant car seat on top to protect the child in the lower position from possible finger entrapment 24 Operating Instructions · Attach top infant car seat by lining up the locking latches with the adapter sockets and pressing down until they lock into place · Attach the lower infant car seat by lining up the locking latches with the LICS sockets and press down until they lock into place IMPORTANT: Top and lower infant car seats can be either forward or rear facing Important Reminders · DO NOT use extension adapters with the top seat. They are only for use with the bassinet or infant car seat. [. . . ] · The infant car seat in the lower position must always be removed first prior to child or infant car seat in the top position · The fabric guard should always be used with an infant car seat on top to protect the child in the lower seat from possible finger entrapment 25 CHILD BOOSTER SEATTM Stroller Configurations · Shown with optional accessories (sold separately) 26 CHILD BOOSTER SEATTM Stroller Configurations * * Extension adapters MUST be used in this configuration 27 CHILD BOOSTER SEATTM Stroller Configurations · Shown with optional accessories (sold separately) * * * Extension adapters MUST be used in this configuration 28 Care and Maintenance Frame. Fabric · Wipe the frame with a damp cloth and mild soap. Use clean, dry cloth or towel to wipe away excess water and soap. [. . . ]