User manual BRITAX KID PLUS

[. . . ] Garantiekarte / Übergabe-Check 19 User instructions We are pleased that our KID plus may accompany your child safely through a new stage of his or her life. In order to protect your child correctly, the KID plus must always be used and installed as described in these instructions. If you have any further questions regarding its use, please feel free to contact us. 2 Adjusting the width of the seat cushion . [. . . ] To adjust the height of the headrest 3 to fit your child: Grasp the adjustment handle 8 by the back of the headrest 3 and pull it upwards slightly. You can now adjust the released headrest 3 to the desired height. As soon as you have let go of the adjustment handle 8, the headrest will engage. Place the child seat on the vehicle seat. Have your child sit down in the child seat and check the height. Repeat this process until the headrest 3 is at the optimal height. 4 Reclining position of the backrest The backrest 2 of the child seat adapts smoothly to the slant of the vehicle seat. The backrest 2 is held vertically by a small notch. Press the backrest 2 slightly to the rear to release the notch. Please observe: The best possible protection can only be ensured if the vehicle seat is in its upright position. The backrest 2 of the child seat can be inclined backwards into a reclining position independent of the the vehicle seat. To do so, fold out the displacement angle 9 on the back of the backrest 2. Now incline the backrest 2 backwards until the displacement angle 9 lies flat along the back of the vehicle seat. Do not incline the backrest 2 farther than specified by the displacement angle 9. 5 Securing your child The KID plus does not require installation in the vehicle. Your child is simply secured with the vehicle seat belt. Fastening the vehicle seat belt Place the child seat on the vehicle seat. Please be sure that the backrest 2 lies flat along the back of the vehicle seat (see 3. If the headrest of the vehicle seat is bothersome, simply turn it around. Pull out the vehicle seat belt and guide it in front of your child to the vehicle seat buckle 10. Engage the buckle tongue in the vehicle seat buckle 10. Inserting the vehicle seat belt into the red belt guides of the child seat. [. . . ] Unhook the elastic loops 13 of the seat cushion 1. Unhook the buttonholes 19 of the headrest 3. Pull the stopper 17 out of the cover of the wings 15. 3 Re-fitting the cover Simply proceed in the reverse order. [. . . ]