User manual BRITAX KIDFIX

[. . . ] We are pleased that our RÖMER KIDFIX may accompany your child safely through a new stage of his or her life. In order to protect your child correctly, the RÖMER KIDFIX must always be used and installed as described in these instructions. If you have any further questions regarding its use, please feel free to contact us. 1 with the KIDFIX locking arms into the ISOFIX fastening points in the vehicle (semi-universal) 4 2. [. . . ] The child safety seat is always secured when it is in the vehicle, even if no child is being transported. to protect your vehicle · Some vehicle seat covers of sensitive materials (e. ) may develop wear marks when child seats are used. This can be avoided by placing a blanket or towel under the child seat. 1 Fastening with the KIDFIX locking arms the RÖMER KIDFIX is installed permanently in the vehicle with the KIDFIX locking arms. Your child is then buckled into the child seat with the vehicle's 3-point seatbelt. Clip the two insert guides 16*, recess facing upwards, to the two ISOFIX fastening points 20. The ISOFIX fastening points 20 are located between the surface and the backrest of the vehicle seat. * The insert guides make it easier to install the seat using ISOFIX and prevent the seat cover from becoming damaged. When not in use, they should be removed and kept in a safe place. If your vehicle has folding backrests, remove the insert guides before folding them down. Grasp the seat surface though the access slot in the cover. pull the adjusting lever 21 upwards and hold it. Push the KIDFIX locking arms 15 out all the way. Push the green safety button 22 and the red release button 23 on both KIDFIX locking arms 15 towards each other. This ensures that both hooks on the KIDFIX locking arms 15 are open and ready to use. Take hold of the seat cushion 1 with both hands. Push both KIDFIX locking arms 15 into the insert guides 16, until the KIDFIX locking arms 15 engage on both sides. The green safety button 22 must now be visible on both sides. Push the seat cushion 1 to the rear against the backrest of the vehicle seat (see 3. Pull on the seat cushion 1 to ensure it is engaged on both sides. 2 Removal with KIDFIX locking arms Pull the adjusting lever 21 upwards and pull the seat cushion 1 all the way forward. [. . . ] In this case, only use the child seat on the rear seat. Tighten the vehicle seat belt by pulling on the diagonal seat belt section 6. For the safety of your child, please check that. The lap belt section 11 runs through the light red belt guides 12 on both sides of the seat cushion, · The diagonal seat belt section 6 on the side of the vehicle seatbelt buckle 10 also runs through the light red belt guide 12 of the seat cushion, The diagonal seat belt section 6 runs through the dark red belt holder 7 of the headrest, · The diagonal seat belt section 6 runs diagonally backward, · The straps are tight and not twisted, The vehicle seatbelt buckle 10 is not positioned between the light red belt guide 12 and the armrest of the seat cushion. [. . . ]