User manual BRITAX STEELCRAFT AGILE

[. . . ] 5 parts. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . stroller frame opening. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . to fit and remove the wheel guards. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . rear wheel fitting and removal. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] to do this, press in and hold the release button, then disconnect one side of the armbar. E rotate the armbar clear of the stroller seat. Lock the armbar back into position after fastening the child in the harness. 16 strOLLEr assEMbLY & OpEratiON 13. aDjUstiNg thE backrEst CAUTION:Ensurethatyourchild'slimbsareinsidetheseatingareabeforeadjustingthe backrest. Bepreparedtosupportyourchild'sweightwhenadjustingthebackrest a to adjust up or down , fully lift the adjusting lever all the way up. b continue to hold the lever up and adjust the seat to any one of three positions. c there are 3 indicated seat positions while the seat is facing forward or rearward. 1. strOLLEr sEat rEMOVaL warNiNg - always remove your child from the stroller seat before removing, installing or changing seat direction. a to remove the seat, firstly, place the seat in the most layback position #3, see section 13c. b hold the seat or armbar on both sides with your hands. then with your finger or thumbs, press down and hold the grey buttons. c while holding the grey buttons, lift the seat out of the frame. 17 strOLLEr assEMbLY & OpEratiON 15. tO facE thE sEat iN OppOsitE DirEctiON. warNiNg: always remove your child from the stroller seat before changing seat direction. a refer to section 14 for removing the seat from the frame. b refer to section 11 for fitting the seat to the frame. 16. tO aDjUst thE hEaD piLLOw & shOULDEr harNEss hEight NOtE: the head pillow has a small height adjusting range for additional comfort. a the head pillow height is adjustable. the harness shoulder strap height also moves with the head pillow. b Unzip the pocket located on the rear side of the stroller seat to reveal the head pillow slider. c hold the slider and squeeze the two buttons together. slide up or down to adjust the head pillow height as desired, then zip the pocket closed. 18 strOLLEr assEMbLY & OpEratiON 17. tO fit, UsE aND rEMOVE thE caNOpY a to attach the canopy, slide the canopy mouldings onto the frame mouldings until they connect together. b attach the canopy hook strips to the pile strips around the top of the frame for a secure fit. c to adjust the canopy, open by pulling forward, or close by pushing it backward. D for extra protection, pull visor out from under front of canopy. E to expose the mesh section of the canopy, unzip the center section. f the zip should be fully unzipped to expose the center mesh section. 19 strOLLEr assEMbLY & OpEratiON 17. tO fit, UsE aND rEMOVE thE caNOpY - cONtiNUED g the window cover is kept in place by a hidden magnet located at the bottom of the window cover. h to open the window cover, roll up the cover and secure with the elastic and toggle. i to remove the canopy, pull the canopy off the frame mouldings. 18. tO UsE thE baskEt NOtE: when a child is in the second seat, basket access is recommended only from the sides, or from the front on 4 wheel models only. there is no front access to the basket on 3 wheel models. a access is available from either side by undoing the zippers. b access is available from the front by undoing the zipper on 4 wheel models only. c access is available from the rear of the stroller. 23 strOLLEr assEMbLY & OpEratiON 25. tO UsE thE fOOtMUff (pUrchasED sEpEratELY) NOtE: always secure the harness through the strap holes before use. a to prepare the stroller for fitment of the footmuff, firstly, ensure the head pillow height is correctly adjusted for your child, see section 16. fold the canopy back, disengage one side of the armbar and rotate to the side of the frame, see section 12D. b Undo the buckle prongs from the buckle housing, then release the buckle rings from the buckle prongs. remove the reversible seat pad & shoulder pads. c to fit the footmuff into the stroller, first unzip the top section from the padded bottom section and set the top section aside. place the padded bottom section into the stroller seat. D thread the harness through the slots in the footmuff. start by threading both lap strap buckle prongs through the pair of slots in the middle section of the footmuff. E the footmuff features 3 pairs of shoulder strap slots to cater for different shoulder strap height positions. thread the shoulder strap buckle rings through the appropriate shoulder strap slots in the footmuff. f thread the buckle housing & crotch pad through the crotch slot in the footmuff. fit the reversible shoulder pads if desired. 24 strOLLEr assEMbLY & OpEratiON 25. tO UsE thE fOOtMUff - cONtiNUED g the footmuff is now ready for use. place the child in the stroller and connect the harness buckle. [. . . ] tO UsE thE sEcOND sEat - cONtiNUED 31. 5 Reversible shoulder pads NOtE: the shoulder pads are reversible. a fit the reversible shoulder pads by fitting around the harness shoulder strap and attach the hook and pile. b repeat for the other reversible shoulder pad. c the reverse side of the shoulder pad has a different fabric pattern. to reverse, undo the hook and pile and reattach on the reverse side. 31. 6 To adjust the head pillow and harness shoulder strap height position a the head pillow has a small height adjusting range. attach to the best suited hook and pile position as required. b the harness straps are threaded through the head pillow so the shoulder strap height is adjusted when the head pillow height is adjusted. 42 sEcOND sEat assEMbLY & OpEratiON 31. tO UsE thE sEcOND sEat - cONtiNUED 31. 7 To fold the Second Seat while attached to the frame WARNING: remove the child from the second seat before attempting to fold NOtE: fold the second seat before folding the stroller. a fold the canopy back, then fully lift up the backrest adjusting lever and hold in this position. b at the same time, push down on the second seat, the foot end of the second seat slide will slide up and stop at the safety lock position (lowest recline position). c the image above shows the second seat at the safety lock position (lowest recline position). ss5 ss5 D while still holding the backrest adjusting lever up, slide the grey safety lock button (ss5) up, then lower the head end of the second seat. E continue to lower the second seat, the foot end of the second seat will slide up the frame to the folded position. f the second seat is shown in the fully folded position above. [. . . ]