User manual BROTHER HL-2600CN

[. . . ] Brother Color Laser Printer HL-2600CN Series User's Guide Version 0 Before you can use the printer, you must set up the hardware and install the driver. Please set up the printer while referring to the Quick Setup Guide. Please read this manual thoroughly before using the printer and keep the CD-ROM in a convenient place for quick and easy reference at all times. Please visit our user support web site, Brother Solutions Center, at http://solutions. brother. com. [. . . ] 3. Press the Power button and turn the printer Off. Open the Front Cover and then open the Top cover. To release the lock, pull the green Belt Cartridge Lock Levers on both sides toward you. Fig. 5-13 4. Remove the OPC Belt Cartridge from the printer. Fig. 5-14 5-19 CHAPTER 5 MAINTENANCE 5. Remove the Tension Release Pins from both sides of the new OPC Belt Cartridge. Fig. 5-15 Remove the protective sheet from the new OPC Belt Cartridge. Do not touch the green part of the OPC Belt Cartridge. Fig. 5-16 6. Insert the new Belt Cartridge into the printer guides with the flat side facing you. Fig. 8. To lock the cartridge into the printer, press the Belt Cartridge Lock Levers that are on both sides of the OPC Belt Cartridge to the rear. Close the Front Cover and the Top Cover. 5-20 CHAPTER 5 MAINTENANCE 9. Press the Power button to turn the printer On. 10. Press any of the Menu buttons (+, ­ , Set or Back) to take the printer Off Line. 11. Press + or ­ until "RESET MENU" appears. Press Set to proceed to the next menu level, and then press + or ­ until "PARTS LIFE" appears. 13. Press Set, and then press + until "OPC BELT" appears. The printer is now in the READY state. 5-21 CHAPTER 5 MAINTENANCE OZONE FIILTER ZONE LTER Ozone Filter You will need to replace the Ozone Filter once a year to prevent ozone from coming out of the printer. !Caution You must replace the Ozone Filter once a year. If you do not, it might cause a noticeable odor of Ozone. Replacing the Ozone Filter 1. Slide and remove the Rear Side Cover. Fig. Remove the Ozone Filter Case from the Rear Side Cover. Fig. Insert the new Ozone Filter Case into the Rear Side Cover. Reinstall the Rear Side Cover by sliding it into place. 5-22 CHAPTER 5 MAINTENANCE FUSIING UNIIT US NG N T Fusing Unit When the following message appears on the LCD panel, you must replace the Fusing Unit: REPLACE FUSER !" READY !Warning The Fusing Unit and the parts around it are HOT! [. . . ] Envelopes that are rough, highly textured, or deeply embossed. Envelopes that do not lie flat or that are curled, wrinkled, or irregularly shaped. Envelopes having an open flap with an adhesive that seals the envelope. USE OF ANY OF THE ENVELOPES LISTED ABOVE MAY CAUSE DAMAGE TO YOUR PRINTER. SUCH DAMAGE IS NOT COVERED UNDER ANY WARRANTY OR SERVICE AGREEMENT. Note The manufacturer neither warrants nor recommends the use of a particular envelope because envelope properties are subject to change by the envelope manufacturer. [. . . ]