User manual BROTHER HS-5000

[. . . ] English: CS-5xxx User's Guide, Preliminary (TOC) Please read this manual thoroughly before using the printer. Brother Color Printer HS-5000/5300 User's Guide Keep this manual in a convenient place for quick and easy reference at all times. English: CS-5zxx User's Guide, Preliminary (TOC) USER'S GUIDE SHIPMENT OF THE PRINTER If for any reason you must ship your Printer, carefully package the Printer to avoid any damage during transit. It is recommended that you save and use the original packaging. The Printer should also be adequately insured with the carrier. Warning When shipping the printer, re-pack it after waiting 30 minutes with the power off which will allow the printer to cool down and the ink to solidify. [. . . ] If you see any problems on printouts, clean the print head and try again. Release the two buttons immediately after pressing the Test button and the DATA LED will start to blink. If it does not, the buttons were held down for too long and you will need to start the test selection again. Note Do not open the top cover during the head cleaning operation. Do not press with too much force or hold the buttons down for a long time. If you do the operation might now start. 4­4 English: CS3 User's Guide, Chapter 4 CHAPTER 4 CONTROL PANEL Test Print Mode The printer has the following test print modes. Keep the Online button depressed until all four LEDs light. The Alarm LED blinks to indicate that the first choice, Print Config, is selected. Press the Online button to select another test. Every time you press the button, the blinking LED changes to select another choice. Press the FF/Cont button to perform the selected choice. LED Alarm Manual Data Ready Choice Print Config Print Fonts I Print Fonts P Test Print Function The printer prints the current printer settings. The printer prints a list of the printer resident fonts. The printer prints a list of the permanent download fonts. The printer returns to the ready status after printing. Note Press the buttons gently. Do not press with too much force or hold the buttons down for a long time. If you do the operation might now start. 4­5 English: CS3 User's Guide, Chapter 4 USER'S GUIDE Reset and Hex Dump print mode The printer has the following Reset and Hex Dump print modes. Keep the FF/Cont button depressed until all four LEDs light. The printer enters the reset/hex dump mode. The Alarm LED blinks to indicate that the first choice, User Reset, is selected. Press the Online button to select another choice. Every time you press the button, the blinking LED changes to indicate another choice. [. . . ] You may be using the printer out of the environment range shown in Chapter 1. Adjust the position of the head gap lever. Poor Transparency print quality. The ink on printouts flakes off. Some colors might be lighter than expected. Vertical lines are not straight. White horizontal lines exist or the printed image is faint. After setting the printer offline by pushing the Online Button once, execute head cleaning by pushing the Clean button while holding the Shift button. Set the Enhancement mode ON in the Quality/Color tab of your printer driver. The print image does not match the printing area. Select the Recommended Paper setting of the printer driver to get a wider printing area in Windows 3. 1x/95/98. [. . . ]